Provisioning Access Points
Chapter 2
Connecting the Console Terminal
Manual provisioning requires this procedure. You must use the serial console breakout adapter cable to be able to access the serial console interface to the Aruba AP 60/61 while allowing the device to be powered by the AC adapter or POE (from an Aruba Mobility Controller).
Console Connection | Console Connection | ||
via direct access to AP | via networking closet | ||
Aruba AP | Console | Console | |
Terminal | Terminal | ||
| |||
|
| LAN | |
Serial |
| Serial | |
Breakout | Breaout |
Deployed Location
Aruba AP
FIGURE 2-3 Aruba AP 60/61 Console Topologies
NOTE: The LAN connections are optional unless POE is used to power the AP.
Console Access to the AP
2
1 "To AP" Connector to AP FE Port
"To Network" Connector |
|
to FE Coupler |
|
3 to LAN FE Cable | To LAN |
FIGURE 2-4 Connecting Directly to the AP
1.Connect the adapter’s “To AP”
2.Connect the adapter’s
3.Connect the adapter’s “To Network”
14 Aruba AP 60/61 | 0500160 |
Installation Guide | December 2005 |