D-Link DI-514 manual Important Note

Page 60

LIMITED WARRANTY, EVEN IF D-LINK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. THE SOLE REMEDY FOR A BREACH OF THE FOREGOING LIMITED WARRANTY IS REPAIR, REPLACEMENT OR REFUND OF THE DEFECTIVE OR NON-CONFORMING PRODUCT. THE MAXIMUM LIABILITY OF D-LINK UNDER THIS WARRANTY IS LIMITED TO THE PURCHASE PRICE OF THE PRODUCT COVERED BY THE WARRANTY. THE FOREGOING EXPRESS WRITTEN WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ANY OTHER WARRANTIES OR REMEDIES, EXPRESS, IMPLIED OR STATUTORY

Governing Law: This Limited Warranty shall be governed by the laws of the State of California. Some states do not allow exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the foregoing limitations and exclusions may not apply. This limited warranty provides specific legal rights and the product owner may also have other rights which vary from state to state.

Trademarks: D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered trademarks are the property of their respective manufacturers or owners.

Copyright Statement: No part of this publication or documentation accompanying this Product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems, Inc., as stipulated by the United States Copyright Act of 1976. Contents are subject to change without prior notice. Copyright© 2002 by D-Link Corporation/D-Link Systems, Inc. All rights reserved.

CE Mark Warning: This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment; such modifications could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for this equipment must be installed to provide a separation distance of at least eight inches (20 cm) from all persons.

This equipment must not be operated in conjunction with any other antenna.

For detailed warranty outside the United States, please contact corresponding local D-Link office.

60

Image 60
Contents Link Air DI-514 Contents Package Contents Introduction Connections Features and Benefits Leds Wireless Basics Wireless Basics Link Air DWL 700AP, DWL-AirPlus DWL-900AP+ DWL-2000AP+Link AirPlus DWL-800AP+ Link AirPlus DWL-810+Installation Considerations Getting Started Link Air DWL-650Link Air DWL-520 Setting Up an Infrastructure Network Getting StartedUsing the Configuration Menu Type admin in the User Name field lower caseSetup Wizard Home Wireless WirelessHome Wizard Channel Key TypeHome WAN Dynamic IP AddressSecondary DNS Address optional PPPoE Home LAN Home Dhcp DhcpAdvanced Virtual Server Virtual ServerPage Advanced Applications Advanced Filters FiltersMAC Filters Advanced Firewall Domain BlockingAdvanced DMZ Advanced Performance Tools Admin Authentication Select Open system, Shared Key or AutoSystem Settings Tools SystemTime Tools Firmware Tools MiscStatus Device Info Log Settings Status LogStatus Wireless Connected Wireless Clients ListStatus Stats Traffic StatisticsTroubleshooting Configure the DI-514 Access PointTroubleshooting Manager Double-click on Network Resetting the DI-514 to Factory Default Settings Using the Network Setup Wizard in Windows XP Networking BasicsNetworking Basics Enter a Computer description and a Computer name optional Networking Basics Networking Basics Networking Basics Network Setup Wizard Windows XP Right-click on My Computer Select Properties and clickComputer Name Tab in the System Properties window Click Change…Select Workgroup and enter the name of the Workgroup Area Connection icon in the task barSupport Tab Double-click on Control PanelAssigning a Static IP Address in Windows XP/2000 Highlight Internet Protocol TCP/IP Preferences Select Built-in EthernetInput the Static IP Address, Subnet Mask and the Router IP Click Apply NowSystem Preferences Select Built-in Ethernet in the Show pull-down menuFor Windows XP For Windows ME and 98SETechnical Specifications Encryption 64/128 bit RC4 Media Access ControlStandards VPN Pass Through / Multi-SessionsWireless Transmit Power 15dBm ± 2dB External Antenna Type Operating Temperature 32F to 131F 0C to 55C HumidityPower Input Safety & Emissions Technical Support Technical SupportWarranty USA only Page Important Note Page Registration