Linksys BEFSR11, BEFSR41 manual Power on the Cable or DSL modem

Page 14

EtherFast Cable/DSL Routers

4.Connect the power-supply cable to the Power port on the rear of the Router, then plug the supplied AC power cable into a power outlet. Plug the other end into the back of the power adapter.

•The Power LED will illuminate green as soon as the power adapter is connected.

•The Diag LED will illuminate red for a few seconds while the Router goes through its internal diagnostic test. The LED will turn off when the self-test is complete.

5.Power on the Cable or DSL modem.

6.Press the Reset button on the front of the router. Hold the button in for three seconds, or until the Diag LED illuminates red. This restores the router’s default settings.

The Hardware Installation is complete. Continue to the next page to con- figure the router’s settings.

11

Image 14

Contents EtherFast Copyright & Trademarks Table of Contents Linksys EtherFast Cable/DSL Router FeaturesIntroduction Package Contents System RequirementsGetting to Know the 4-Port EtherFast Cable/DSL Router 4-Port Router’s Rear Panel4-Port Router’s Front Panel LEDs Link/ActReset Button Getting to Know the One-Port EtherFast Cable/DSL Router One-Port Router’s Rear PanelReset Button One-Port Router’s Front Panel LEDs10/100 About Static & Dynamic IP Addresses Connecting the Cable/DSL Router to Your NetworkOverview Connecting Everything Together & Booting Up Power everything downPower on the Cable or DSL modem Configuring Your Network with EtherFast Cable/DSL Routers Click Apply, then click Continue Configuring Your PCs to Connect to the Cable/DSL Router Instant Broadband Series Quick & Easy Administration Cable/DSL Router’s Web- based UtilitySetup EtherFast Cable/DSL Routers Password Status Dhcp Help To Modify Filter Settings FiltersForwarding Dynamic Routing Static Routing Instant Broadband Series DMZ Host Troubleshooting Common Problems and SolutionsWhen I enter a URL or IP address, I get a time out error Frequently Asked Questions With the Router and requires no special settings NAT and TCP/IP port inspections Tion of your public IPs and Domain How to Ping Your ISP’s E-mail & Web Addresses AppendixStep Two Pinging for a Web Address Instant Broadband Series Installing the TCP/IP Protocol TCP/IP Installation is complete Twisted-Pair Cabling Crimping Your Own Network Cables Port Router Specifications EnvironmentalOne-Port Router Specifications Customer Support Copyright 2000 Linksys, All Rights Reserved