Linksys BEFSR11, BEFSR41 manual 10/100

Page 11

 

Instant Broadband Series

Full/Col

Green. The Full/Col LED also serves two purposes. If this

 

LED is continuously illuminated, a connection is being suc-

 

cessfully maintained through the LAN port. If the LED is

 

flickering, the connection is experiencing collisions.

 

Infrequent collisions are normal. If this LED is flickering

 

too often, there may be a problem with your connection.

 

Check the Troubleshooting section on page 30 if you think

 

there is a problem.

10/100

Orange. The 10/100 LED illuminates when a successful

 

100Mbps connection is made through the corresponding

 

port. If a 10Mbps connection is being made, the light will

 

not be illuminated.

The WAN Indicators

Link

Green. The Link LED illuminates when a successful con-

 

nection is made between the Router and your Broadband

 

device or network.

Act

Green. The Act LED flickers when the Router is sending or

 

receiving data over the broadband port.

Diag

Red. The Diag LED illuminates when the Router goes

 

through its self-diagnosis mode during boot-up. It will turn

 

off upon successful completion of the diagnosis. If this

 

LED stays on for an abnormally long period of time, refer

 

to Troubleshooting on page 30.

8

Image 11
Contents EtherFast Copyright & Trademarks Table of Contents Linksys EtherFast Cable/DSL Router FeaturesIntroduction System Requirements Package Contents4-Port Router’s Rear Panel Getting to Know the 4-Port EtherFast Cable/DSL RouterLink/Act 4-Port Router’s Front Panel LEDsReset Button One-Port Router’s Rear Panel Getting to Know the One-Port EtherFast Cable/DSL RouterOne-Port Router’s Front Panel LEDs Reset Button10/100 About Static & Dynamic IP Addresses Connecting the Cable/DSL Router to Your NetworkOverview Power everything down Connecting Everything Together & Booting UpPower on the Cable or DSL modem Configuring Your Network with EtherFast Cable/DSL Routers Click Apply, then click Continue Configuring Your PCs to Connect to the Cable/DSL Router Instant Broadband Series Cable/DSL Router’s Web- based Utility Quick & Easy AdministrationSetup EtherFast Cable/DSL Routers Password Status Dhcp Help Filters To Modify Filter SettingsForwarding Dynamic Routing Static Routing Instant Broadband Series DMZ Host Common Problems and Solutions TroubleshootingWhen I enter a URL or IP address, I get a time out error Frequently Asked Questions With the Router and requires no special settings NAT and TCP/IP port inspections Tion of your public IPs and Domain Appendix How to Ping Your ISP’s E-mail & Web AddressesStep Two Pinging for a Web Address Instant Broadband Series Installing the TCP/IP Protocol TCP/IP Installation is complete Twisted-Pair Cabling Crimping Your Own Network Cables Environmental Port Router SpecificationsOne-Port Router Specifications Customer Support Copyright 2000 Linksys, All Rights Reserved