Actiontec electronic PCMCIA manual Installing the Modem

Page 13

3 Installing the Modem

The Modem comes with its own dedicated phone cable. This cable has a standard RJ-11 connector on one end for the phone line, and a special connector that fits into the Modem on the other end. Insert the cable into the Modem, as shown in the figure, below.

MCaution: Be careful not to push the computer against anything when the cable is in place. This may bend the connector and damage the pins. Keep the area around the com-

puter clear, so the computer can move freely without damaging the cable or connector.

Next, go to chapter 4, “Installing the Driver Software,” to load the software used by the Modem onto the computer.

10

Image 13

Contents PC Card Fax Modem User Guide Table of Contents Table of Contents Introduction Package ContentsSystem Requirements Technical Support Before You Begin Installing Point EnablerDOS and Windows Before You Begin Windows 95 Windows NT Pcmcia Settings COM 2 Settings Before You Begin Installing Modem Installing the Modem Windows 95a Installing Driver SoftwareInstalling the Driver Software Windows 95 OSR2 Installing the Driver Software Windows Installing the Driver Software Alternate Windows 98 Installation Installing the Driver Software Windows Me Windows NT DataLink V.90 Pcmcia Fax Modem Installing the Driver Software Is installed Installing the Driver Software DataLink V.90 Pcmcia Fax Modem Installing the Driver Software DataLink V.90 Pcmcia Fax Modem Installing the Driver Software Windows XP Installing the Driver Software Installing Communcations Software Installing the Communcations Software Uninstalling the Modem TroubleshootingProblems and Solutions Cannot Open COM Port Error Windows 95a Windows 95 OSR2 Limited Warranty Limited Warranty DataLink V.90 Pcmcia Fax Modem Limited Warranty