Actiontec electronic PCMCIA manual Windows 95

Page 8

DataLink V.90 PCMCIA Fax Modem

Windows 95 and 98

If the Modem is the first PC Card purchased for the notebook computer, ensure the computer’s PCMCIA controller has been initialized and properly configured for Windows 95 and 98 by following these instructions:

1.After booting up the computer, select Start, Settings, then Control Panel.

2.In the “Control Panel” window, double-click PC Card. A properly installed PCMCIA controller causes the “PC Card (PCMCIA) Properties” window to appear.

If the “New Hardware Found” window appears, the computer’s PCMCIA ports have not been configured. Follow the installation instructions in the window, and refer to the computer’s documentation for more information.

The computer is configured to use the Modem. Next, go to chpater 3, “Installing the Modem,” to continue installing and configuring the Modem.

5

Image 8

Contents PC Card Fax Modem User Guide Table of Contents Table of Contents System Requirements Package ContentsIntroduction Technical Support DOS and Windows Installing Point EnablerBefore You Begin Before You Begin Windows 95 Pcmcia Settings Windows NTCOM 2 Settings Before You Begin Installing Modem Installing the Modem Installing Driver Software Windows 95aInstalling the Driver Software Windows 95 OSR2 Installing the Driver Software Windows Installing the Driver Software Alternate Windows 98 Installation Installing the Driver Software Windows Me Windows NT DataLink V.90 Pcmcia Fax Modem Installing the Driver Software Is installed Installing the Driver Software DataLink V.90 Pcmcia Fax Modem Installing the Driver Software DataLink V.90 Pcmcia Fax Modem Installing the Driver Software Windows XP Installing the Driver Software Installing Communcations Software Installing the Communcations Software Problems and Solutions TroubleshootingUninstalling the Modem Cannot Open COM Port Error Windows 95a Windows 95 OSR2 Limited Warranty Limited Warranty DataLink V.90 Pcmcia Fax Modem Limited Warranty