Actiontec electronic PCMCIA manual Windows 95 OSR2

Page 16

DataLink V.90 PCMCIA Fax Modem

Windows 95 OSR2

To load the Modem’s software drivers onto a computer running Windows 95 OSR2:

1.Turn on the computer.

2.Insert the Modem into the computer’s PCMCIA slot.

3.Windows detects the Modem, and the first “Update Device Driver Wizard” window appears. Insert the DataLink Installation CD in the computer’s CD-ROM drive and click Next.

4.Another “Update Device Driver” window appears. After Windows has found the driver software for the Modem, click the Finish button.

5.If Windows asks for an installation disk, click OK, then Other Locations. Select the CD-ROM drive and click OK again. The driver software is installed.

13

Image 16

Contents PC Card Fax Modem User Guide Table of Contents Table of Contents Introduction Package ContentsSystem Requirements Technical Support Before You Begin Installing Point EnablerDOS and Windows Before You Begin Windows 95 Pcmcia Settings Windows NTCOM 2 Settings Before You Begin Installing Modem Installing the Modem Installing Driver Software Windows 95aInstalling the Driver Software Windows 95 OSR2 Installing the Driver Software Windows Installing the Driver Software Alternate Windows 98 Installation Installing the Driver Software Windows Me Windows NT DataLink V.90 Pcmcia Fax Modem Installing the Driver Software Is installed Installing the Driver Software DataLink V.90 Pcmcia Fax Modem Installing the Driver Software DataLink V.90 Pcmcia Fax Modem Installing the Driver Software Windows XP Installing the Driver Software Installing Communcations Software Installing the Communcations Software Uninstalling the Modem TroubleshootingProblems and Solutions Cannot Open COM Port Error Windows 95a Windows 95 OSR2 Limited Warranty Limited Warranty DataLink V.90 Pcmcia Fax Modem Limited Warranty