14Patch Release Note
PCR: 03205 Module: DHCP | Level: 2 |
The following issues with DHCP have been resolved:
•DHCP assigned an incorrect IP address to clients shifting from a relayed to a
•DHCP clients shifting between relayed ranges were not always recognised, and were occasionally allocated incorrect addresses.
•DHCP offered entries did not time out after a NAK on a bad lease time request.
PCR: 03206 | Module: IPG | Level: 3 |
IPv4 filters now behave like IPv6 filters.
PCR: 03208 | Module: FIREWALL | Level: 2 |
When the configuration script was created using the CREATE CONFIG command, the GBLIP parameter in the ADD FIREWALL POLICY command was listed twice. This caused the command to fail when the device was restarted. This issue has been resolved.
PCR: 03211 | Module: SWI | Level: 2 |
When the MARL table had been fully populated, the addition of another multicast group caused an entry to be deleted, and the new entry was not added. This issue has been resolved so that no more groups can be added when the table is full.
PCR: 03212 | Module: IPV6 | Level: 3 |
The TRACE command was not working when using an ipv6
PCR: 03213 | Module: IPSEC | Level: 3 |
A memory leak occurred when some IPSEC processes failed. This issue has been resolved.
PCR: 03216 | Module: PIM, PIM6 | Level: 2 |
PIM4 and PIM6 were not sending Hello packets if the HELLOINTERVAL was not a multiple of 10. This is set with the ADD PIM INTERFACE, ADD PIM6 INTERFACE, SET PIM INTERFACE, and SET PIM6 INTERFACE commands. This issue has been resolved.
PCR: 03222 | Module: PIM, PIM6 | Level: 2 |
If the RP candidate advertising time was set to a
PCR: 03229 Module: LOAD | Level: 3 |
Zmodem was not naming some loaded files. This issue has been resolved.
Patch