Allied Telesis 86251-05 manual PCR 03333 Module IPGLevel, PCR 03334 Module MVRLevel

Page 18

18Patch Release Note

PCR: 03321

Module: DHCP, Q931, TELNET

Level: 4

Debugging for DHCP and Q931 was not being disabled when a Telnet

session finished. This issue has been resolved.

 

PCR: 03332

Module: TTY

Level: 2

A log message is now created when a user is forced to logout from an asynchronous port when another user (i.e. someone connected via Telnet) resets the asynchronous connection with the RESET ASYN command.

PCR: 03333 Module: IPGLevel: 3

After VRRP was enabled, the link status of the switch ports was shown as UP, even if there was no connection to the ports. This issue has been resolved.

PCR: 03334 Module: MVRLevel: 3

The SET IP MVR command now has extra error checking. This is to ensure that if the IMTLEAVE parameter is not specified, the original range of ports set by the CREATE IP MVR command are still contained within the newly specified port range.

PCR: 03336

Module: CORE

Level: 4

“AT-A42” was being incorrectly displayed as “AT-A42X-00” in the output

of the SHOW SYSTEM command. This issue has been resolved.

 

PCR: 03341

Module: STP

Level: 3

STP ignored some BPDU packets coming in on tagged ports. This issue has been resolved. Now the VLAN tag is ignored on all devices except Rapier i Series Switches with multiple STPs on the receiving port.

PCR: 03345

Module: IPG

Level: 4

The RESET IP COUNTER=ALL command was not working correctly when

issued from the command line. This issue has been resolved.

 

PCR: 03346

Module: SNMP

Level: 4

Sometimes the Agent Address field in SNMP traps was not the same as the IP source address. This meant that sometimes the NMS did not send an alarm to the network manager when traps were received from switches. This issue has been resolved.

PCR: 03348

Module: SWI

Level: 3

The Uplink card sometimes unnecessarily changed its status from UP to

DOWN. This issue has been resolved.

 

PCR: 03349

Module: BGP

Level: 3

When there were a large number of BGP routes, the SHOW BGP ROUTE command sometimes caused an error. This issue has been resolved.

PCR: 03350 Module: IP, SWILevel: 3

A fatal error occurred if an IP ARP route entry was deleted after an IP route filter was added while the IP route was equal to zero. This issue has been resolved.

Patch 86251-05 for Software Release 2.5.1 C613-10356-00 REV F

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Introduction PCR Module Firewall Level PCR Module IPG LevelPCR Module IPV6 Level PCR 03371 Module Dhcp Level PCR Module SWI LevelPCR Module Ikmp Level PCR Module Http LevelPCR 03424 Module Dhcp Level PCR 03405 Module Stream LevelPCR 03410 Module VLAN, Core Level PCR 03429 Module SWI, Vlan LevelPCR Module IPX Level PCR Module STP LevelPCR 03436 Module IP, Dhcp Level PCR Module L2TP LevelPCR Module PIM Level PCR Module Ospf LevelPCR 03465 Module Dhcp Level PCR Module NTP Level PCR 03492 Module HTTP, Load LevelPCR Module BGP, Firewall Level PCR 03515 Module Dhcp Level PCR Module GUI Level PCR Module IP LevelPCR 02577 Module IPG, LOG Level PCR 03089 Module Core LevelPCR 03109 Module LOG Level PCR 03096 Module Vlan LevelPCR Module PIM, DVMRP, IPG Level PCR Module Ping LevelPCR Module IPG, SWI Level PCR Module Switch LevelPCR Module ETH, IPG Level PCR Module Cure LevelPCR Module FFS Level PCR 03153 Module ACC LevelPCR Module PCI Level PCR 03167 Module Dvmrp LevelPCR Module LB Level PCR Module CORE, FFS, TTY LevelPCR Module FIREWALL, LB Level PCR Module User LevelPCR 03205 Module Dhcp Level PCR Module Ipsec LevelPCR 03229 Module Load Level PCR 03239 Module QOS Level PCR Module SWI, IPG, PIM LevelPCR 03247 Module MVR Level PCR Module VLAN, IPG Level PCR Module PPP LevelPCR 03298 Module FIREWALLLevel PCR 03293 Module PPPLevelPCR 03296 Module IPGLevel PCR 03307 Module IPGLevelPCR 03333 Module IPGLevel PCR 03334 Module MVRLevelPCR 03350 Module IP, SWILevel PCR 03351 Module Dhcp Level PCR 03370 Module MVR LevelPCR 03388 Module Dhcp Level PCR Module Isakmp LevelADD PPP Create PPP Delete PPP SET PPP Show PPP PCR 03077 Module CORELevel PCR 03068 Module SWI, QOSLevelPCR 03069 Module SWILevel PCR Module IPV6 Network affecting NoPCR Module IPG, ETH Network affecting No PCR 03015 Module SWINetwork affecting NoPCR 03032 Module SWINetwork affecting No PCR Module TELNET, PING, IPV6, Network affecting NoPCR 02574 Module DVMRPNetwork affecting No PCR 02527 Module TCPNetwork affecting NoPCR 02552 Module SWINetwork affecting No PCR 02581 Module TMNetwork affecting NoConfiguration Example Commands Show IP IgmpSee Also Show IP Igmp Debug ADD IP Igmp Destination Create IP Igmp Destination Delete IP Igmp Destination Destroy IP Igmp DestinationDisable IP Igmp Debug Enable IP Igmp DebugShow IP Igmp Debug Filter by source IPHow to check that the port map is correct How to restore the correct port map PPPoE Client on Vlan Interfaces ADD PPP Create PPP Delete PPP SET PPPVLANn-servicename, TNL- callname Show PPPShow PPP
Top Page Image Contents