8 | Patch Release Note |
PCR: 03502 | Module: IPG | Level: 3 |
The ENTRY parameter from the ADD IP FILTER command was not included in the output of the SHOW CONFIG DYNAMIC command. This issue has been resolved.
PCR: 03513 | Module: IPG | Level: 3 |
An enhancement allows for the creation of static IGMP group memberships that do not time out. For details on this feature, see “Static IGMP” on page 24.
PCR: 03515 Module: DHCP | Level: 3 |
DHCP was offering network and broadcast addresses to clients. This issue has been resolved.
PCR: 03517 | Module: FIREWALL | Level: 3 |
An error was not returned if the SET FIREWALL POLICY RULE command was executed with PROTOCOL=1 when ICMP forwarding was turned on. This issue has been resolved so that an error is now displayed.
PCR: 03523 | Module: FIREWALL | Level: 2 |
In some circumstances the checksum for the TCP header was set to zero.
This issue has been resolved.
PCR: 03526 | Module: SWI | Level: 3 |
The Switch MIB did not show the correct dot1StpPriority value. This issue has been resolved.
PCR: 03531 | Module: SWI | Level: 3 |
After creating a trunk group, the activity LEDs did not flash unless the configuration was used at reboot. This issue has been resolved so that the LEDs flash correctly whenever a trunk group is created.
PCR: 03468 | Module: PIM | Level: 3 |
The source IP address in a PIM Register message was not the DR interface’s
IP address. This issue has been resolved.
PCR: 03533 | Module: PIM | Level: 3 |
A forwarded
PCR: 03535 | Module: IPG | Level: 2 |
IGMP Query messages were not sent after IGMP was disabled and then re- enabled. This issue has been resolved.
Patch