Patch | 17 |
PCR: 03291 | Module: PPP | Level: 2 |
A PAP authentication failure with PPPoE could cause a fatal error. This | ||
issue has been resolved. |
| |
PCR: 03292 | Module: IP | Level: 3 |
When adding static routes with the ADD IP ROUTE command, the order of the route in the route table was the reverse of the order entered. This issue has been resolved.
PCR: 03293 Module: PPPLevel: 3
The MAXSESSION parameter of the SET PPP ACSERVICE command could not be changed when the service was defined over a VLAN. This issue has been resolved.
PCR: 03296 Module: IPGLevel: 2
Broadcast TCP packets were being processed by the device, causing fatal errors when firewall SMTP Proxy was configured.
PCR: 03298 Module: FIREWALLLevel: 3
The SHOW FIREWALL POLICY was not showing the correct debugging items, as set with the ENABLE FIREWALL POLICY DEBUG command. This issue has been resolved.
PCR: 03300 | Module: FIREWALL | Level: 3 |
Firewall rules were not being applied to broadcast packets received on a | ||
public interface. This issue has been resolved. |
| |
PCR: 03302 | Module: SWI | Level: 3 |
Following a period of high traffic load, the CPU utilisation would |
| |
occasionally fail to drop below 40%. This issue has been resolved. |
| |
PCR: 03306 | Module: IPG | Level: 3 |
IGMP Proxy was setting a delay timer of
PCR: 03307 Module: IPGLevel: 3
IGMP Proxy did not disable the DR status of an existing IGMP interface when that interface became the IGMP Proxy Upstream. IGMP Proxy also did not enable the DR status of an interface when it became anything other than the IGMP Proxy Upstream. These issues have been resolved.
PCR: 03308 | Module: IPG | Level: 3 |
IGMP Proxy now sends an IGMP Leave message once all members have left | ||
an IGMP group. |
| |
PCR: 03317 | Module: OSPF | Level: 2 |
Enabling OSPF via the GUI sometimes caused a fatal error. This issue has been resolved.
Patch