Patch | 23 |
PCR: 03015 Module: SWINetwork affecting: No
When ports were added to a trunk group on a Rapier 16, the ports operated in the wrong duplex mode. This issue has been resolved.
PCR: 03029 | Module: SWI | Network affecting: No |
Layer 3 filtering was not correctly modifying a packet's IPDSCP field. This | ||
issue has been resolved. |
| |
PCR: 03031 | Module: FIREWALL | Network affecting: No |
The ADD FIREWALL POLICY RULE command included an erroneous check on port ranges for
PCR: 03032 Module: SWINetwork affecting: No
If the ENABLE IP IGMP command was executed before the ENABLE SWITCH L3FILTER command, Layer 3 filtering did not discard packets destined for the CPU. This issue has been resolved.
PCR: 03040 | Module: IPG | Network affecting: No |
Sometimes IP flows were not deleted correctly when both directions of the | ||
flow were in use. This issue has been resolved. |
| |
PCR: 03051 | Module: PCI | Network affecting: No |
The ECPAC card was not working correctly. This issue has been resolved.
Features in 86251-01
Patch file details are listed in Table 5:
Table 5: Patch file details for Patch
Base Software Release File | |
|
|
Patch Release Date | |
|
|
Compressed Patch File Name | |
|
|
Compressed Patch File Size | 11884 bytes |
|
|
Patch
PCR: 02331 | Module: IPG, ETH | Network affecting: No |
IP is now informed when an Ethernet interface goes up or down, after a 2.5 second delay.
PCR: 02525 | Module: TELNET, PING, IPV6, Network affecting: No |
| TCP |
The ADD IPV6 HOST command was not accepting the INTERFACE parameter when adding a host with a
Patch