34 | SHOW IP IGMP DEBUG | Patch Release Note |
Although the ifIndex and Interface numbers do not match, this is the correct port map.
You do not need to take any more action if you have the correct port map.
An incorrect port map
If the
Figure 2: Example output from the SHOW INTERFACE command without 86251-04.paz installed
Interfaces |
| sysUpTime: | 00:01:22 |
DynamicLinkTraps | Disabled |
|
|
TrapLimit | 20 |
|
|
Number of unencrypted | PPP/FR links | 0 |
|
ifIndex Interface | ifAdminStatus | ifOperStatus | ifLastChange |
1 | port1 | Up | Down | 00:00:00 |
2 | port2 | Up | Down | 00:00:00 |
3 | port3 | Up | Down | 00:00:00 |
4 | port4 | Up | Down | 00:00:00 |
5 | port5 | Up | Down | 00:00:00 |
6 | port6 | Up | Down | 00:00:00 |
7 | port7 | Up | Down | 00:00:00 |
8 | port8 | Up | Down | 00:00:00 |
9 | port9 | Up | Down | 00:00:00 |
10 | port10 | Up | Down | 00:00:00 |
11 | port11 | Up | Down | 00:00:00 |
12 | port12 | Up | Down | 00:00:00 |
13 | port13 | Up | Down | 00:00:00 |
14 | port14 | Up | Down | 00:00:00 |
15 | port15 | Up | Down | 00:00:00 |
16 | port16 | Up | Down | 00:00:00 |
17 | vlan1 | Up | Down | 00:00:00 |
Although the ifIndex and Interface numbers match, this port map is incorrect.
You must restore the correct port map if your Rapier16fi shows this output.
How to restore the correct port map
The correct port map is restored with the following steps:
5. Force an EPROM download to restore the bootrom.
To force an EPROM download, you have to restart the switch. To restart the switch, use the command:
RESTART REBOOT
When the switch starts up, you will see the messages in Figure 3 on page 35.
Patch