6 | Patch Release Note |
PCR: 03454 | Module: IPV6 | Level: 3 |
Occasionally, removing the cable from an IPv6 interface caused the device to stop responding. This issue has been resolved.
PCR: 03456 | Module: PIM | Level: 2 |
A VLAN interface receiving a PIM Prune message on a port stopped forwarding multicast data to that port too early. This could cause multicast data to arrive after a PIM Prune, so an override PIM Join message was not sent, leading to a loss of multicast data. This issue has been resolved.
PCR: 03457 | Module: OSPF | Level: 2 |
Disabling OSPF caused a fatal error if there was a large routing table. This issue has been resolved.
PCR: 03459 | Module: IPV6 | Level: 2 |
A fatal error sometimes occurred when packets were forwarded via an IPv6 interface, and IPv6 flows were disabled. This issue has been resolved.
PCR: 03461 | Module: IPG | Level: 3 |
The ENABLE IP MVR DEBUG=ALL command was erroneously shown in the output of the SHOW CONFIG DYNAMIC=IP command. This SHOW output no longer includes the ENABLE IP MVR DEBUG=ALL entry.
PCR: 03462 | Module: PIM, PIM6 | Level: 3 |
PIM Graft and
PCR: 03465 Module: DHCP | Level: 3 |
The IPMTU parameter in the ADD DHCP POLICY command was accepting values in the range
PCR: 03463 | Module: PIM, PIM6 | Level: 3 |
PCR: 03464 | Module: PIM, PIM6 | Level: 3 |
PCR: 03467 | Module: IPG | Level: 3 |
An invalid message appeared when the PORT parameter was specified for the ADD IP ROUTE command. This issue has been resolved.
PCR: 03471 | Module: IPV6 | Level: 2 |
A fatal error sometimes occurred when forwarding traffic over an IPv6 tunnel. This issue has been resolved.
Patch