Figure 9 (CLIP Connection Setup)
To complete the connection you must now click the apply button. The apply button will temporarily save this connection. To make the change permanent you need to click on Save Settings (at the side of the page). At the system commands page, click on Save All.
4.4.2 Modify an Existing Connection
To modify an existing connection, click setup and then click the connection you want to modify. The connections are listed as Connection 0 through Connection 7
As a note, if you delete the connection, to make the change permanent you need to click on Save Settings (at the side of the page). At the system commands page, click on Save All.
4.4.3 Modem setup
To configure the DSL modulation type, Click setup. Under WAN Setup, select Modem Setup. This will bring up the modem setup screen. Leave the default value if you are unsure or the DSL/ISP did not provide this information. For most all cases, this screen should not be modified.
The apply button will temporarily save this connection. To make the change permanent you need to click on Save Settings (at the side of the page). At the system commands page, click on Save All.
- 17 -