Allied Telesis AT-AR236E manual DSL Link LED continues to blink but does not go solid

Page 35

5.3The DSL Link LED continues to blink but does not go solid

1.This means that the DSL line is trying to train but for some reason it cannot establish a valid connection. The main cause of this is that you are too far away from the central office. Contact your DSL service provider for further assistance.

2.Verify that the phone line is connected directly to the wall and to the line input on the ADSL Router.

3.Make sure that for every parallel phone line connected to telephone or fax to install with a micro filter.

5.4The DSL Link LED is always off

1.Make sure you have DSL service. You should get some kind of information from your ISP that states that DSL service is installed. You can usually tell if the service is installed by listening to the phone line; you will hear some high-pitched noise. If you do not hear high-pitched noise, contact your ISP.

2.Verify that the phone line is connected directly to the wall and to the line input on the ADSL Router. If the phone line is connected to the phone side of the ADSL Router or you have a splitter installed on the phone line, the DSL light will not come on.

- 35 -

Page 34 Page 36
Image 35
Page 34 Page 36
Contents Web Interface User’s Guide Wide Area Network connection Local Area Network connection Introduction FeaturesManagement Support LED description Your gateway at a glancePorts and buttons Installing your Adsl Router Log into your Adsl Router Setting up your Adsl RouterQuick Start Quick StartLocal Area Network connection Setup for advance userWide Area Network connection Bridged gateway profile and Connection Configuring the WANNew Connection PPPoA Connection Setup Page PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Modify an Existing Connection Modem setupEnable/Disable Dhcp Configuring the LANStatic IP address assignment Changing the Adsl Router IP addressFirewall/NAT Services UPnP Advanced for advance user onlyPort Forwarding Advanced Security DMZ configurationEnable Incoming Icmp Ping Access ControlEnable Web from WAN Enable Remote TelnetMAC Filters MAC Address FiltersMulticast MulticastStatic Routing Dynamic Routing User Management System CommandsTools Update Firmware Modem Test Ping TestStatus System Log Can’t connect to the Adsl Router Appendix a TroubleshootingAdsl Router is not functional DSL Link LED is always off DSL Link LED continues to blink but does not go solidAdsl Router terms What is a firewall?
Top Page Image Contents