Allied Telesis AT-AR236E manual Tools, System Commands, User Management

Page 29

4.7Tools

The ADSL Router supports a host of tools that will allow you to customize and debug your ADSL Router.

4.7.1 System Commands

To make the changes permanent you need to click on Tools (at the top of the page) and select System Commands. The following commands are used to configure the gateway:

a.Save all: Press this button in order to permanently save the current configuration of the ADSL Router. If you do re-start the system without saving your configuration, the ADSL Router will revert back to the previously saved configuration.

b.Restart: Use this button to re-start the system. If you have not saved your configurations, the ADSL Router will revert back to the previously saved configuration upon re-starting.

NOTE: Connectivity to the unit will be lost. You can reconnect after the unit reboots.

c.Restore Defaults: Use this button to restore factory default configuration.

NOTE: Connectivity to the unit will be lost. You can reconnect after the unit reboots.

4.7.2 User Management

You can change your ADSL Router’s username and password by clicking on User Management. From here you can change the login name and password. You can also change the idle timeout; you will need to log back onto the ADSL Router once the timeout expires.

If you forget your password, you can press and hold the reset to factory defaults button for 10 seconds (or more). The ADSL Router will reset to its factory default configuration and all custom configurations will be lost.

The apply button will temporarily save this connection. To make the change permanent you need to click on Save Settings (at the side of the page). At the system commands page, click on Save All.

- 29 -

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Web Interface User’s Guide Wide Area Network connection Local Area Network connection Introduction FeaturesManagement Support LED description Your gateway at a glancePorts and buttons Installing your Adsl Router Log into your Adsl Router Setting up your Adsl RouterQuick Start Quick StartLocal Area Network connection Setup for advance userWide Area Network connection Bridged gateway profile and Connection Configuring the WANNew Connection PPPoA Connection Setup Page PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Modify an Existing Connection Modem setupEnable/Disable Dhcp Configuring the LANStatic IP address assignment Changing the Adsl Router IP addressFirewall/NAT Services UPnP Advanced for advance user onlyPort Forwarding Advanced Security DMZ configurationEnable Web from WAN Access ControlEnable Remote Telnet Enable Incoming Icmp PingMAC Filters MAC Address FiltersMulticast MulticastStatic Routing Dynamic Routing User Management System CommandsTools Update Firmware Modem Test Ping TestStatus System Log Can’t connect to the Adsl Router Appendix a TroubleshootingAdsl Router is not functional DSL Link LED is always off DSL Link LED continues to blink but does not go solidAdsl Router terms What is a firewall?
Top Page Image Contents