Allied Telesis AT-AR236E manual Update Firmware

Page 30

4.7.3 Update Firmware

You can remotely upgrade the ADSL Router’s firmware, clicking on Update Firmware under the Tools page. This will bring up the screen shown in Figure 19. The upgrade file shall be in *.img format.

To upgrade the firmware, click browse, find the firmware file to download. Make sure this is the correct file. Click on upgrade firmware (as shown in Figure 19). Once the upgrade is complete the ADSL Router will reboot. You will need to log back onto the ADSL Router after the firmware upgrade is completed.

The firmware upgrade should take about 5 minutes to complete.

Note: Do not remove power from the ADSL Router during the firmware upgrade procedure.

Figure 19 (Update Firmware)

- 30 -

Image 30

Contents Web Interface User’s Guide Wide Area Network connection Local Area Network connection Features IntroductionManagement Support Your gateway at a glance Ports and buttonsLED description Installing your Adsl Router Setting up your Adsl Router Log into your Adsl RouterQuick Start Quick StartSetup for advance user Wide Area Network connectionLocal Area Network connection Configuring the WAN New ConnectionBridged gateway profile and Connection PPPoA Connection Setup Page PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Modem setup Modify an Existing ConnectionConfiguring the LAN Enable/Disable DhcpChanging the Adsl Router IP address Static IP address assignmentFirewall/NAT Services Advanced for advance user only UPnPPort Forwarding DMZ configuration Advanced SecurityEnable Remote Telnet Access ControlEnable Web from WAN Enable Incoming Icmp PingMAC Address Filters MAC FiltersMulticast MulticastStatic Routing Dynamic Routing System Commands ToolsUser Management Update Firmware Ping Test Modem TestStatus System Log Appendix a Troubleshooting Adsl Router is not functionalCan’t connect to the Adsl Router DSL Link LED continues to blink but does not go solid DSL Link LED is always offWhat is a firewall? Adsl Router terms