Installing the HSSI Module
3.Insert the HSSI module into an uncovered I/O slot. Make sure the flipper ejector(s) are in an open position.
Flipper | Flipper |
open | closed |
With the connector end toward the backplane and the board facing up (check that the labels on the connector/LED panel are right side up), grasp the left and right sides of the panel and fit the board into the I/O slot opening along the guide rails.
4.Lock the board in the slot.
For the
1
2
3
4
STATUS |
8
7
6
5
Push board into slot
5.Check that the connector/LED panel of the newly inserted module is flush with the NETBuilder II chassis.
To verify that the board is seated correctly, check that it is aligned with the connector/LED panel of an installed module.
6.Hand tighten the captive screws. Do not use a screwdriver.
A solid connection of the connector/LED panel to the chassis is required for proper operation. Do not use the screws to force the board into place.