3Com 9150, 9550 manual WPA2-Only

Page 39

System Configuration

35

Only allows WPA clients to connect to the VAP.

You can choose TKIP or AES as the encryption method

The Group key update interval is configurable; the default value is 1800 seconds

You can choose personal mode (PSK) or enterprise mode (802.1X) authentication The default is PSK.

If you choose PSK, you will need to enter a pass phrase of 8-63 ASCII characters or 64 hexadecimal digits.

If you choose 802.1X, you will need access to a RADIUS server, port and secret.

WPA2-Only

Only allows WPA 2 clients to connect to the VAP.

You can choose TKIP or AES for the encryption method

The Group key update interval is configurable, with a default value of 1800 seconds

You can choose personal mode (PSK) or enterprise mode (802.1X) authentication. The default is PSK.

If you choose PSK, you will need to enter a pass phrase of 8-63 ASCII characters or 64 hexadecimal digits.

If you choose 802.1X, you will need access to a RADIUS server, port and secret.

Image 39

Contents 3Com AirConnect 9550 11n 2.4+5GHz PoE Access Point Page 3Com Corporation 350 Campus Drive Marlborough, MA Environmental Statement Introduction Ssid Bssid Iapp Troubleshooting Antennas Used per Mode Console Cable Pin-out Page Security Key Product FeaturesManageability Performance and Reliability802.11a Wireless Network Standards802.11b/g Ieee 802.3af Installing Your 3com Wireless Access Point Networks with a Dhcp Server Access PointNetworks without a Dhcp Server 3Com Wireless Wireless Infrastructure Device Manager Launching the 3Com Wireless Infrastructure Device Manager3Com Wireless Infrastructure Device Manager Click on the Properties button to see the following screen Logon Screen System Status First Time OnlySystem Summary System Summary Wireless Station List Wireless Station ListEvent Log List Event Log ListSetup Wizard System Configuration4G Radio Wireless Network WEP System Properties 4G Wireless Security SettingsWireless Bridge Mode Access Point modeIP Settings Wireless Network Wireless NetworkWireless Mode Standard ChannelCurrent Profiles Ssid Profile Settings Station Separation Suppressed SsidWEP SecurityWPA Only WPA2-Only WDS Link Settings WPA2-MixedProfile Ssid Isolation System Configuration WEP WPA-PSK Tkip WPA-PSK AES WDS Security SettingsWireless Advanced Settings Transmit PowerFragment Length Association TimeoutBeacon Interval Data Beacon RateAggregation Support 802.11d supportDistance Antenna TypeQoS Management Vlan Service802.11F Iapp Support Choose either Enable or DisableClick Add Ack-Policy Setting DescriptionDefault value table Sntp Following settings can be configured System Log Syslog FunctionSyslog Server Syslog PortSyslog Level Management AdministrationSnmp MAC Filtering Access Control ListRogue AP Detection Rogue AP DetectionBackup/Restore Settings Backup/ Restore SettingsFirmware Auto Upgrade Firmware Auto UpgradeFirmware Upgrade Firmware Manual UpgradeResult Reboot RebootingConnecting Through the Com Port Reset Hole Location Restoring Factory SettingsDiagnosing Problems TroubleshootingSymptom Solution s Disconnecting the Access Point Upgrading Access Point Firmware Telephone Technical Support and Repair 3COM ProductTelephone Technical Support and Repair END-USER License Agreement Telephone Technical Support and Repair Appendix Antennas Used per ModeMode Antennas Used Console Cable Pin-out RJ45 to D-SUB 9 pin cable Console Cable Pin-out Numerics IndexSsid WPA