3Com 9550, 9150 manual Wireless Mode, Standard Channel, Current Profiles

Page 34

30System Configuration

Wireless Mode

You can select your desired wireless operating mode from the drop-down box.

Standard Channel

Select the channel for your wireless LAN in Standard Channel block. The default setting is SmartSelect. It selects the channel which provides the best transmission quality. The available frequencies vary depending on which wireless mode you select.

Current Profiles

A maximum of four profiles can be configured. Check the Enable button to activate a profile. Click the Edit button to change its configuration.

Image 34
Contents 3Com AirConnect 9550 11n 2.4+5GHz PoE Access Point Page 3Com Corporation 350 Campus Drive Marlborough, MA Environmental Statement Introduction Ssid Bssid Iapp Troubleshooting Antennas Used per Mode Console Cable Pin-out Page Key Product Features SecurityPerformance and Reliability ManageabilityWireless Network Standards 802.11a802.11b/g Ieee 802.3af Installing Your 3com Wireless Access Point Access Point Networks with a Dhcp ServerNetworks without a Dhcp Server Launching the 3Com Wireless Infrastructure Device Manager 3Com Wireless Wireless Infrastructure Device Manager3Com Wireless Infrastructure Device Manager Click on the Properties button to see the following screen Logon Screen First Time Only System StatusSystem Summary System Summary Wireless Station List Wireless Station ListEvent Log List Event Log ListSystem Configuration Setup Wizard4G Radio Wireless Network WEP 4G Wireless Security Settings System PropertiesAccess Point mode Wireless Bridge ModeIP Settings Wireless Network Wireless NetworkStandard Channel Wireless ModeCurrent Profiles Ssid Profile Settings Suppressed Ssid Station SeparationSecurity WEPWPA Only WPA2-Only WPA2-Mixed WDS Link SettingsProfile Ssid Isolation System Configuration WDS Security Settings WEP WPA-PSK Tkip WPA-PSK AESTransmit Power Wireless Advanced SettingsData Beacon Rate Association TimeoutBeacon Interval Fragment LengthAntenna Type 802.11d supportDistance Aggregation SupportQoS Service Management VlanChoose either Enable or Disable 802.11F Iapp SupportClick Add Setting Description Ack-PolicyDefault value table Sntp Following settings can be configured Syslog Function System LogSyslog Port Syslog ServerSyslog Level Administration ManagementSnmp Access Control List MAC FilteringRogue AP Detection Rogue AP DetectionBackup/ Restore Settings Backup/Restore SettingsFirmware Auto Upgrade Firmware Auto UpgradeFirmware Manual Upgrade Firmware UpgradeResult Rebooting RebootConnecting Through the Com Port Restoring Factory Settings Reset Hole LocationTroubleshooting Diagnosing ProblemsSymptom Solution s Disconnecting the Access Point Upgrading Access Point Firmware 3COM Product Telephone Technical Support and RepairTelephone Technical Support and Repair END-USER License Agreement Telephone Technical Support and Repair Antennas Used per Mode AppendixMode Antennas Used Console Cable Pin-out RJ45 to D-SUB 9 pin cable Console Cable Pin-out Index NumericsSsid WPA