3Com 9150, 9550 manual 802.11d support, Distance, Antenna Type, Aggregation Support

Page 45

System Configuration

41

802.11d support

802.1d allows the device to communicate in areas where the

802.11standard is not allowed. It adds features and restrictions to ensure compliance.

Distance

The maximum distance between client or AP and device. The default value is 1km.

Antenna Type

If you would like to use external antennas (to replace the original internal antennas), check External Antenna. Then specify one of the antenna types from the drop down menu, where the options are:

■

■

■

3CWE591 3com 6/8dBi Dual-Band Omni Antenna

3CWE596 3com 18/20dBi Dual-Band Panel Antenna

3CWE598 3com 8/10dBi Dual-Band Panel Antenna

Aggregation Support

Sets the aggregation type:

■

■

A-MPDU : Aggregate MAC protocol data unit.

A-MSDU : Aggregate MAC service data unit.

The default value is A-MPDU.

Image 45

Contents 3Com AirConnect 9550 11n 2.4+5GHz PoE Access Point Page 3Com Corporation 350 Campus Drive Marlborough, MA Environmental Statement Introduction Ssid Bssid Iapp Troubleshooting Antennas Used per Mode Console Cable Pin-out Page Security Key Product FeaturesManageability Performance and Reliability802.11a Wireless Network Standards802.11b/g Ieee 802.3af Installing Your 3com Wireless Access Point Networks with a Dhcp Server Access PointNetworks without a Dhcp Server 3Com Wireless Wireless Infrastructure Device Manager Launching the 3Com Wireless Infrastructure Device Manager3Com Wireless Infrastructure Device Manager Click on the Properties button to see the following screen Logon Screen System Status First Time OnlySystem Summary System Summary Wireless Station List Wireless Station ListEvent Log List Event Log ListSetup Wizard System Configuration4G Radio Wireless Network WEP System Properties 4G Wireless Security SettingsWireless Bridge Mode Access Point modeIP Settings Wireless Network Wireless NetworkWireless Mode Standard ChannelCurrent Profiles Ssid Profile Settings Station Separation Suppressed SsidWEP SecurityWPA Only WPA2-Only WDS Link Settings WPA2-MixedProfile Ssid Isolation System Configuration WEP WPA-PSK Tkip WPA-PSK AES WDS Security SettingsWireless Advanced Settings Transmit PowerBeacon Interval Association TimeoutData Beacon Rate Fragment LengthDistance 802.11d supportAntenna Type Aggregation SupportQoS Management Vlan Service802.11F Iapp Support Choose either Enable or DisableClick Add Ack-Policy Setting DescriptionDefault value table Sntp Following settings can be configured System Log Syslog FunctionSyslog Server Syslog PortSyslog Level Management AdministrationSnmp MAC Filtering Access Control ListRogue AP Detection Rogue AP DetectionBackup/Restore Settings Backup/ Restore SettingsFirmware Auto Upgrade Firmware Auto UpgradeFirmware Upgrade Firmware Manual UpgradeResult Reboot RebootingConnecting Through the Com Port Reset Hole Location Restoring Factory SettingsDiagnosing Problems TroubleshootingSymptom Solution s Disconnecting the Access Point Upgrading Access Point Firmware Telephone Technical Support and Repair 3COM ProductTelephone Technical Support and Repair END-USER License Agreement Telephone Technical Support and Repair Appendix Antennas Used per ModeMode Antennas Used Console Cable Pin-out RJ45 to D-SUB 9 pin cable Console Cable Pin-out Numerics IndexSsid WPA