3Com 9550, 9150 manual WPA2-Mixed, Profile Ssid Isolation, WDS Link Settings

Page 40

36System Configuration

WPA2-Mixed

Only allows WPA and WPA2 clients to connect to the VAP.

You can choose TKIP or AES as the encryption method.

The Group key update interval is configurable, with a default value of 1800 seconds.

You can choose personal mode (PSK) or enterprise mode (802.1X) authentication. The default setting is PSK.

If you choose PSK, you will need to enter a pass phrase of 8-63 ASCII characters or 64 hexadecimal digits.

If you choose 802.1X, you will need access to a RADIUS server, port and secret.

Profile (SSID) Isolation

Stations connected to different profiles cannot access each other. Choose from No Isolation (Full access), or to Isolate all Profiles (SSIDs) from each other, check use VLAN (802.1Q) standard.

WDS Link Settings

Wireless Distribution System (WDS) allows access points to communicate with one another wirelessly in a standardized way. It can also simplify the network infrastructure by reducing the amount of cabling required.

Image 40

Contents 3Com AirConnect 9550 11n 2.4+5GHz PoE Access Point Page 3Com Corporation 350 Campus Drive Marlborough, MA Environmental Statement Introduction Ssid Bssid Iapp Troubleshooting Antennas Used per Mode Console Cable Pin-out Page Key Product Features SecurityPerformance and Reliability ManageabilityWireless Network Standards 802.11a802.11b/g Ieee 802.3af Installing Your 3com Wireless Access Point Access Point Networks with a Dhcp ServerNetworks without a Dhcp Server Launching the 3Com Wireless Infrastructure Device Manager 3Com Wireless Wireless Infrastructure Device Manager3Com Wireless Infrastructure Device Manager Click on the Properties button to see the following screen Logon Screen First Time Only System StatusSystem Summary System Summary Wireless Station List Wireless Station ListEvent Log List Event Log ListSystem Configuration Setup Wizard4G Radio Wireless Network WEP 4G Wireless Security Settings System PropertiesAccess Point mode Wireless Bridge ModeIP Settings Wireless Network Wireless NetworkStandard Channel Wireless ModeCurrent Profiles Ssid Profile Settings Suppressed Ssid Station SeparationSecurity WEPWPA Only WPA2-Only WPA2-Mixed WDS Link SettingsProfile Ssid Isolation System Configuration WDS Security Settings WEP WPA-PSK Tkip WPA-PSK AESTransmit Power Wireless Advanced SettingsAssociation Timeout Beacon IntervalData Beacon Rate Fragment Length802.11d support DistanceAntenna Type Aggregation SupportQoS Service Management VlanChoose either Enable or Disable 802.11F Iapp SupportClick Add Setting Description Ack-PolicyDefault value table Sntp Following settings can be configured Syslog Function System LogSyslog Port Syslog ServerSyslog Level Administration ManagementSnmp Access Control List MAC FilteringRogue AP Detection Rogue AP DetectionBackup/ Restore Settings Backup/Restore SettingsFirmware Auto Upgrade Firmware Auto UpgradeFirmware Manual Upgrade Firmware UpgradeResult Rebooting RebootConnecting Through the Com Port Restoring Factory Settings Reset Hole LocationTroubleshooting Diagnosing ProblemsSymptom Solution s Disconnecting the Access Point Upgrading Access Point Firmware 3COM Product Telephone Technical Support and RepairTelephone Technical Support and Repair END-USER License Agreement Telephone Technical Support and Repair Antennas Used per Mode AppendixMode Antennas Used Console Cable Pin-out RJ45 to D-SUB 9 pin cable Console Cable Pin-out Index NumericsSsid WPA