3Com 11.1 manual ROUte

70CHAPTER 69: SR SERVICE PARAMETERS

ROUte

Syntax ADD !<port> -SR ROUte <media address> [Override] [Dec Hex] [ Transparent {Null <source route> [<largestframesize>]}]

DELete !<port> -SR ROUte <media address>

SHow [!<port> !*] -SR ROUte [[Cmac Ncmac] %<media address>] [Dec Hex] SHowDefault [!<port> !*] -SR ROUte [[Cmac Ncmac] %<media address>] [Dec Hex]

Default

Description

Values

No default

The ROUte parameter configures, deletes, and displays a static route for a remote end system.

<media address>	Specifies the media address of a remote station. Must be 12
	hexadecimal digits and preceded by a percent sign (%).
	Use the Cmac keyword when the media address is entered in
	canonical format and the Ncmac keyword when the media
	address is entered in noncanonical format.
	If neither Cmac nor Ncmac is specified, the current setting of
	the -SYS MacAddrFormat parameter is used.
Override	Specifies that the static route can be replaced by a learned
	route if the route has been determined to be inoperational.
Dec Hex	Specifies that the route information is entered or displayed in
	decimal (Dec keyword) or hexadecimal format (Hex keyword).
Transparent	Specifies that no RIF be used on frames sent to the specified
	address; the target is on the local ring or reached via
	transparent bridges. The default is a transparent spanning
	tree route.
Null	Specifies that a null RIF is used; the target is on the local ring.
<source route>	Specifies a source as a sequence of rings and bridges in the
	order in which a source-routed packet traverses the source
	route bridged network. The route is specified as follows:
	:<ring_number>&<bridge_number>[:<ring_number>]...
	A ring number must be preceded by a colon (:), and a bridge
	number must be preceded by an ampersand (&). The
	following is an example of a route where the source route
	packet initiated at Ring 25 is forwarded through Bridge 2
	onto Ring 4 before reaching its end system destination:
	:25&2:4
	A valid route must begin with a ring number that matches the
	ring number assigned to the specified port. If the last element
	specified in <route> is a bridge number, that element is
	ignored.