Advantech PPC-155T Hardware Installation, Jumpers and Connectors, Disassembling the Panel PC

Page 34

Chapter 4 Hardware Installation

4.1Jumpers and Connectors

The panel PC consists of a PC-based computer that is housed in a metal shielding case with a plastic cover on the rear and bottom. All the computer devices, like the CPU, HDD, SDRAM, and power supply are all readily accessible after removing the rear panel or the HDD cover. Any maintenance or hardware upgrades can be easily completed after removing the rear panel and/or HDD cover.

For information about complete disassembly of the panel PC, refer to Appendix B.

Warning! Do not remove the plastic rear cover until verifying that no power is flow- ing within the panel PC. Power must be switched off and the power cord must be unplugged. Each time the panel PC is serviced, users should be aware of this condition.

4.2Disassembling the Panel PC

The following are standard procedures for disassembling the panel PC before upgrading the system. All procedures are illustrated in Fig. 4-1, 4-2, 4-3 and 4-4.

1.Unscrew the side cover on the plastic HDD cover to expose the HDD module. The Type II CF slot lies underneath the HDD module.

Figure 4.1 Unfastening the HDD side cover

PPC-155T User Manual

22

Image 34

Contents PPC-155T Copyright Acknowledgements Product Warranty 2 years Declaration of ConformityTechnical Support and Assistance FCC Class BDocument Feedback Packing ListAdditional Information and Assistance Contact informationSafety Instructions Wichtige Sicherheishinweise Safety Precaution Static Electricity Page Using the Panel PC ChapterAppendix a Appendix BChapter General Information SpecificationsIntroduction General Information Certifications Dimensions Dimensions of PPC-155TPage System Setup System Setup Quick Tour of the Panel PCSystem Setup Running the Bios Setup Program Installation ProceduresPreparing for First-time Use Installing System Software Installing the DriversPage Using the Panel PC Using the Panel PC CD-ROM Drive optionalPcmcia PS/2 Mouse and KeyboardPCI Bus Expansion PCI bus expansionVGA Port Serial COM PortsUSB Ports Ethernet Audio InterfaceFront Bezel LED and Light Sensor Touchscreen Optional Page Hardware Installation Jumpers and Connectors Hardware InstallationDisassembling the Panel PC Hardware Installation Installing the 2.5 Hard Disk Drive PPC without the Rear CoverPlugging in the Eide cable Installing the Central Processing Unit CPU Placing the CPU in the socketTightening the screws on the CPU 11 Fastening the CPU module to the motherboard Installing the DDR Sdram Memory Module 12 Placing the memory module in the DimmPage Jumpers Connectors Jumpers & Connectors Setting jumpersJumpers & Connectors Jumper and Connector Locations Connectors Page Driver Installation Driver Installation Driver InstallationUpdating Driver Searching on the Advantech Website Appendix a Appendix a Disassembly Disassembly ProcedureAppendix a Disassembly Figure A.4 The PPC without the rear cover Figure A.6 Unfastening the middle plate Figure A.8 Unfastening the HDD module Figure A.10 Disconnecting the HDD cable Figure A.12 Loosening the screws on the CD-ROM module Figure A.14 Removing the fixed brace Figure A.16 Removing the CD-ROM / Pcmcia slot cover Figure A.18 Disconnecting the CD-ROM connector Figure A.20 Unfastening the CPU socket Figure A.22 Removing the Sdram module Page Appendix B Figure B.1 PCI Card Dimensional Limits Appendix B PCI Card Size Limits