Advantech PPC-155T user manual Installing the 2.5 Hard Disk Drive, PPC without the Rear Cover

Page 36

Figure 4.4 The PPC without the Rear Cover

4.3Installing the 2.5" Hard Disk Drive

One enhanced Integrated Device Electronics (IDE) hard disk drive may be attached to the panel PC's internal controller which uses a PCI local-bus interface. The follow- ing instructions are for installing the HDD:

1.A metal plate holds the HDD to the upper right-hand side of the metal shielding case. (See Fig. 4-5.) Fix the two screws on the metal plate of two side of HDD.

2.Connect IDE cable from main board.

3.Place the HDD on the metal plate, and tighten the four screws from the bottom of the metal plate.

Figure 4.5 Fastening the HDD metal frame to the HDD

PPC-155T User Manual

24

Image 36

Contents PPC-155T Copyright Acknowledgements Product Warranty 2 years Declaration of ConformityTechnical Support and Assistance FCC Class BDocument Feedback Packing ListAdditional Information and Assistance Contact informationSafety Instructions Wichtige Sicherheishinweise Safety Precaution Static Electricity Page Using the Panel PC ChapterAppendix a Appendix BChapter Specifications General InformationIntroduction General Information Certifications Dimensions Dimensions of PPC-155TPage System Setup System Setup Quick Tour of the Panel PCSystem Setup Installation Procedures Running the Bios Setup ProgramPreparing for First-time Use Installing System Software Installing the DriversPage Using the Panel PC Using the Panel PC CD-ROM Drive optionalPcmcia PS/2 Mouse and KeyboardPCI Bus Expansion PCI bus expansionSerial COM Ports VGA PortUSB Ports Audio Interface EthernetFront Bezel LED and Light Sensor Touchscreen Optional Page Hardware Installation Hardware Installation Jumpers and ConnectorsDisassembling the Panel PC Hardware Installation Installing the 2.5 Hard Disk Drive PPC without the Rear CoverPlugging in the Eide cable Installing the Central Processing Unit CPU Placing the CPU in the socketTightening the screws on the CPU 11 Fastening the CPU module to the motherboard Installing the DDR Sdram Memory Module 12 Placing the memory module in the DimmPage Jumpers Connectors Jumpers & Connectors Setting jumpersJumpers & Connectors Jumper and Connector Locations Connectors Page Driver Installation Driver Installation Driver InstallationUpdating Driver Searching on the Advantech Website Appendix a Appendix a Disassembly Disassembly ProcedureAppendix a Disassembly Figure A.4 The PPC without the rear cover Figure A.6 Unfastening the middle plate Figure A.8 Unfastening the HDD module Figure A.10 Disconnecting the HDD cable Figure A.12 Loosening the screws on the CD-ROM module Figure A.14 Removing the fixed brace Figure A.16 Removing the CD-ROM / Pcmcia slot cover Figure A.18 Disconnecting the CD-ROM connector Figure A.20 Unfastening the CPU socket Figure A.22 Removing the Sdram module Page Appendix B Figure B.1 PCI Card Dimensional Limits Appendix B PCI Card Size Limits