3Use the two rack screws to secure the system to the front rail of the rack.
Important Be sure to tighten the rack screws so that the system is firmly attached to the rack.
You can use the Phillips screwdriver to tighten these screws.
Parts of the unit may be |
|
covered by clear plastic film that | Insert and tighten the two mounting |
protected it during shipment. Remove the film. | screws to secure the unit to the rack. |
Secure the System in the Rack or Cabinet
Once you have mounted the system and attached it to the front of the rack, you must secure it at the back.
Follow these steps to secure the system at the back.
1At the back of the system, locate the small hole in the lip that extends beyond the back panel on the side of the enclosure.
This hole is next to the mounting bracket.
2Insert a small,
Secure the unit to the rack by inserting a small screw through each of the holes located on both sides on the back of the unit. Tighten the screws to attach the unit to the
3Insert and tighten a small screw on the other side of the system.
Mounting Xserve RAID in a Rack | 35 |