Metrologic Instruments MS7620 manual Power Save Modes and IR Detection

POWER SAVE MODES AND IR DETECTION

The MS7600 has five programmable power save modes. Refer to the MetroSelect Programming Guide for additional information on Power Save Modes.

1.Blink Power Save Mode:

Blinks the laser OFF & ON after a programmed period of non-use. When the scanner recognizes a bar code it will exit the Blink mode.

2.Laser Off Power Save Mode:

Turns the laser OFF after a programmed period of non-use. The motor continues to spin allowing for a faster “wake” up time.

Any movement detected by the IR will “wake” the scanner from the Laser Off power save mode (see figure 27).

3.Laser & Motor Off Power Save Mode:

Turns the laser and motor OFF after a programmed period of non-use.

Any movement detected by the IR will “wake” the scanner from the power save mode (see figure 27). This mode’s “wake” time is slightly longer due to the motor’s need to restart.

4.Dual Action Power Save Mode #1:

“Blinks” the laser OFF & ON after a programmed period of non-use turns the laser and motor OFF at thirty-minute intervals.

Example:

If the power save timeout is set to 15 minutes.

Last	Laser starts	Laser & Motor
Scan	“Blinking”	turns OFF

Any movement detected by the IR will “wake” the scanner from the power save mode (see figure 27).

5.Dual Action Power Save Mode #2 (Default):

Turns the laser OFF after a programmed period of non-use then turns the motor OFF after thirty-minute intervals.

Example:

If the power save timeout is set to 15 minutes.

Last	Laser turns	Motor turns
Scan	OFF	OFF

Any movement detected by the IR will “wake” the scanner from the power save mode (see figure 27).

26