Metrologic Instruments MS7620 manual Changing the Beeper Tone & Volume

Page 28

CHANGING THE BEEPER TONE & VOLUME

Changing the Beeper Tone

Beeper tones may be programmed directly or incrementally using the following bar code. The new tone will be heard followed by a short pause. Two more new tones will be heard signifying the new setting has been stored in memory. The silent (no beep) tone is also selectable.

Next Beep Tone

³9 9 9 9 7 5

Changing the Beeper Volume

Volume levels may be programmed directly or incrementally using the following bar code. The new volume will be heard followed by a short pause. Two more tones will be heard signifying the new setting has been saved in memory. The silent (no volume) tone is also selectable.

Next Volume

³9 9 9 9 7 4

These volume control and beeper tone bar codes can also be found under the Top plate of the scanner and in the MetroSelect Programming Guide.

Figure 26: Additional Beeper Tone and Volume Control Bar Codes.

25

Image 28
Contents MS7600 Horizon Series Installation and User’s Guide Page Table of Contents Introduction Scanner and Accessories DescriptionReplacement Parts Before Installing Your MS7600 N OT PressMounting the MS7600 Series Package FlowOption B Free Hanging Support Option C Trim Ring Mlpn 46-46641, Additional Purchase Installation for Keyboard Wedge Interface Turn on the host systemInstallation for STAND-ALONE Keyboard Interface Stand-Alone Keyboard InterfaceInstallation for USB Interface If you require USB Point of Sale communication protocolsManufacturers Note Installation for RS232 or Light PEN Interfaces RS232 or Light Pen InterfaceFor RS232 Communication Scan 1st Installation for IBM 46XX Interface RS232/IBM, InterfaceInstallation for Ocia Interface OCIA, InterfaceInstallation of a Secondary Scanner Enable AUX Output Connector Orientation Top Secondary Scanner Setup Bottom O t p Scanner PartsEAS Deactivation Antenna Maintenance3, 4, 5, on SW1 & SW2 Scanner Labels Label LocationsAudible Indicators Three Beeps on power upOne Beep Razzberry ToneVisual Indicators Failure Modes Flashing Amber and One Razzberry ToneFlashing Red and Amber Two Razzberry Tones Continuous Razzberry Tone with both LEDs offChanging the Beeper Tone & Volume Changing the Beeper TonePower Save Modes and IR Detection Power Save Modes and IR Detection Scan Volume Specifications Scan Volume in Plane Perpendicular to FlowDepth of Field by Minimum BAR Code Element Width Minimum Bar Code Element WidthTroubleshooting Guide All InterfacesCodes. The scanner defaults to Keyboard Wedge Only RS-232 Only Aux port operation with any interface Design Specifications Electrical RS232 Demonstration Program Keyboard Type Applications and ProtocolsKeyboard Country Type Default Settings IBM KBW USBDTS/SIEMENS DTS/NIXDORF NCR F NCR S Default Settings ACK/NAK Default Settings Default settings for Aux interface Scanner Pinout Connections Scanner and Cable TerminationsMS762x-37 Keyboard Wedge Stand-Keyboard or USB Cable Connector Configurations Host End Cable Connector Configuration Limited Warranty Avertissement AtenciónAchtung AttenzionePatents Index Light PenUSB Page August