Metrologic Instruments MS7620 manual Failure Modes, Flashing Amber and One Razzberry Tone

Page 27

FAILURE MODES

Figure 25: LEDs

Flashing Amber and One Razzberry Tone

This indicates the scanner has experienced a laser subsystem failure. Return the unit for repair at an authorized service center.

Flashing Red and Amber and

Two Razzberry Tones

This indicates the scanner has experienced a motor failure. Return the unit for repair at an authorized service center.

Continuous Razzberry Tone with both LEDs off

If, upon power up, the scanner emits a continuous razzberry tone, then the scanner has an electronic failure. Return the unit for repair at an authorized service center.

Three Beeps - on power up

If the scanner beeps 3 times on power up then, the nonvolatile memory that holds the scanner configuration has failed. Return the unit for repair at an authorized service center.

24

Image 27
Contents MS7600 Horizon Series Installation and User’s Guide Page Table of Contents Introduction Description Scanner and AccessoriesReplacement Parts N OT Press Before Installing Your MS7600Package Flow Mounting the MS7600 SeriesOption B Free Hanging Support Option C Trim Ring Mlpn 46-46641, Additional Purchase Turn on the host system Installation for Keyboard Wedge InterfaceStand-Alone Keyboard Interface Installation for STAND-ALONE Keyboard InterfaceIf you require USB Point of Sale communication protocols Installation for USB InterfaceManufacturers Note RS232 or Light Pen Interface Installation for RS232 or Light PEN InterfacesFor RS232 Communication Scan 1st RS232/IBM, Interface Installation for IBM 46XX InterfaceOCIA, Interface Installation for Ocia InterfaceInstallation of a Secondary Scanner Enable AUX Output Connector Orientation Top Secondary Scanner Setup Bottom Scanner Parts O t pMaintenance EAS Deactivation Antenna3, 4, 5, on SW1 & SW2 Label Locations Scanner LabelsRazzberry Tone Audible IndicatorsThree Beeps on power up One BeepVisual Indicators Continuous Razzberry Tone with both LEDs off Failure ModesFlashing Amber and One Razzberry Tone Flashing Red and Amber Two Razzberry TonesChanging the Beeper Tone Changing the Beeper Tone & VolumePower Save Modes and IR Detection Power Save Modes and IR Detection Scan Volume in Plane Perpendicular to Flow Scan Volume SpecificationsMinimum Bar Code Element Width Depth of Field by Minimum BAR Code Element WidthAll Interfaces Troubleshooting GuideCodes. The scanner defaults to Keyboard Wedge Only RS-232 Only Aux port operation with any interface Design Specifications Electrical RS232 Demonstration Program Applications and Protocols Keyboard TypeKeyboard Country Type IBM KBW USB Default SettingsDTS/SIEMENS DTS/NIXDORF NCR F NCR S Default Settings ACK/NAK Default Settings Default settings for Aux interface Scanner and Cable Terminations Scanner Pinout ConnectionsMS762x-37 Keyboard Wedge Stand-Keyboard or USB Cable Connector Configurations Host End Cable Connector Configuration Limited Warranty Atención AvertissementAttenzione AchtungPatents Light Pen IndexUSB Page August