Metrologic Instruments MS7620 manual Manufacturers Note

Page 14

INSTALLATION FOR USB INTERFACE

Manufacturers Note:

Plugging the scanner into the USB port of the PC does not guarantee that scanned information will appear at the PC. A software driver and correct configuration setting are also required for proper communication to occur.

6.	Scan the Enable USB Defaults bar					Enable USB Defaults
6.	Scan the Enable USB Defaults bar
	code to configure the MS7600 for
	USB communication.
					³	9			9	9	9		7					8
7.	Turn on the host system.

11

Image 14

Contents MS7600 Horizon Series Installation and User’s Guide Page Table of Contents Introduction Scanner and Accessories DescriptionReplacement Parts Before Installing Your MS7600 N OT PressMounting the MS7600 Series Package FlowOption B Free Hanging Support Option C Trim Ring Mlpn 46-46641, Additional Purchase Installation for Keyboard Wedge Interface Turn on the host systemInstallation for STAND-ALONE Keyboard Interface Stand-Alone Keyboard InterfaceInstallation for USB Interface If you require USB Point of Sale communication protocolsManufacturers Note Installation for RS232 or Light PEN Interfaces RS232 or Light Pen InterfaceFor RS232 Communication Scan 1st Installation for IBM 46XX Interface RS232/IBM, InterfaceInstallation for Ocia Interface OCIA, InterfaceInstallation of a Secondary Scanner Enable AUX Output Connector Orientation Top Secondary Scanner Setup Bottom O t p Scanner Parts3, 4, 5, on SW1 & SW2 MaintenanceEAS Deactivation Antenna Scanner Labels Label LocationsOne Beep Audible IndicatorsThree Beeps on power up Razzberry ToneVisual Indicators Flashing Red and Amber Two Razzberry Tones Failure ModesFlashing Amber and One Razzberry Tone Continuous Razzberry Tone with both LEDs offChanging the Beeper Tone & Volume Changing the Beeper TonePower Save Modes and IR Detection Power Save Modes and IR Detection Scan Volume Specifications Scan Volume in Plane Perpendicular to FlowDepth of Field by Minimum BAR Code Element Width Minimum Bar Code Element WidthTroubleshooting Guide All InterfacesCodes. The scanner defaults to Keyboard Wedge Only RS-232 Only Aux port operation with any interface Design Specifications Electrical RS232 Demonstration Program Keyboard Country Type Applications and ProtocolsKeyboard Type Default Settings IBM KBW USBDTS/SIEMENS DTS/NIXDORF NCR F NCR S Default Settings ACK/NAK Default Settings Default settings for Aux interface Scanner Pinout Connections Scanner and Cable TerminationsMS762x-37 Keyboard Wedge Stand-Keyboard or USB Cable Connector Configurations Host End Cable Connector Configuration Limited Warranty Avertissement AtenciónAchtung AttenzionePatents Index Light PenUSB Page August