Metrologic Instruments MS7620 Applications and Protocols, Keyboard Type, Keyboard Country Type

Page 41

APPLICATIONS AND PROTOCOLS

The model number on each scanner includes the scanner number and factory default communications protocol.

SCANNER		VERSION		COMMUNICATION PROTOCOL(S)
SCANNER		IDENTIFIER		COMMUNICATION PROTOCOL(S)
		IDENTIFIER

7620		13		RS232, IBM 46xx, OCIA, Aux
7625		13		RS232, IBM 46xx, OCIA, Aux
7625

7620		37		RS232, Light Pen, Keyboard Wedge,
7625		37		Stand-Alone Keyboard, USB, Aux
7625				Stand-Alone Keyboard, USB, Aux

The MS7600 with Built-in PC Keyboard Wedge Interface is designed to be used for keyboard emulation only. Many RS-232 programmable functions available in other Metrologic scanners are also available as keyboard wedge functions.

The following are the most important selectable options specific to the keyboard wedge.

Keyboard Type

•** AT (includes IBM® PS2 models 50, 55, 60, 80)

•XT

•IBM PS2 (includes models 30, 70, 8556)

		Keyboard Country Type
•	** USA	•	German	•	Spanish
•	Belgium	•	Italian	•	Swiss
•	French	•	Japan	•	United Kingdom

**Refer to pages 39-44 for complete information on the factory default settings. Refer to the MetroSelect® Programming Guide

(MLPN 00-02407B) or MetroSet 2’s help files for information on how to change the default settings.

38

Image 41

Contents MS7600 Horizon Series Installation and User’s Guide Page Table of Contents Introduction Description Scanner and AccessoriesReplacement Parts N OT Press Before Installing Your MS7600Package Flow Mounting the MS7600 SeriesOption B Free Hanging Support Option C Trim Ring Mlpn 46-46641, Additional Purchase Turn on the host system Installation for Keyboard Wedge InterfaceStand-Alone Keyboard Interface Installation for STAND-ALONE Keyboard InterfaceIf you require USB Point of Sale communication protocols Installation for USB InterfaceManufacturers Note RS232 or Light Pen Interface Installation for RS232 or Light PEN InterfacesFor RS232 Communication Scan 1st RS232/IBM, Interface Installation for IBM 46XX InterfaceOCIA, Interface Installation for Ocia InterfaceInstallation of a Secondary Scanner Enable AUX Output Connector Orientation Top Secondary Scanner Setup Bottom Scanner Parts O t p3, 4, 5, on SW1 & SW2 MaintenanceEAS Deactivation Antenna Label Locations Scanner LabelsThree Beeps on power up Audible IndicatorsOne Beep Razzberry ToneVisual Indicators Flashing Amber and One Razzberry Tone Failure ModesFlashing Red and Amber Two Razzberry Tones Continuous Razzberry Tone with both LEDs offChanging the Beeper Tone Changing the Beeper Tone & VolumePower Save Modes and IR Detection Power Save Modes and IR Detection Scan Volume in Plane Perpendicular to Flow Scan Volume SpecificationsMinimum Bar Code Element Width Depth of Field by Minimum BAR Code Element WidthAll Interfaces Troubleshooting GuideCodes. The scanner defaults to Keyboard Wedge Only RS-232 Only Aux port operation with any interface Design Specifications Electrical RS232 Demonstration Program Keyboard Country Type Applications and ProtocolsKeyboard Type IBM KBW USB Default SettingsDTS/SIEMENS DTS/NIXDORF NCR F NCR S Default Settings ACK/NAK Default Settings Default settings for Aux interface Scanner and Cable Terminations Scanner Pinout ConnectionsMS762x-37 Keyboard Wedge Stand-Keyboard or USB Cable Connector Configurations Host End Cable Connector Configuration Limited Warranty Atención AvertissementAttenzione AchtungPatents Light Pen IndexUSB Page August