Metrologic Instruments MS700i manual Configuration of the Scanner to the Host System

Page 7

Configuration of the Scanner to the Host System

The scanner is shipped from the factory programmed to a set of default conditions. These default conditions are in the Default Settings section of this guide pages 36-41 and in the ScanSelect™ Scanner Programming Guide. The default settings in the ScanSelect guide have an asterisk that appears before the brief definition next to the bar code.

For the scanner to properly communicate with the host system, it needs to be programmed to meet the specific scanning needs. Since each host system is unique, configure the scanner to match the host system requirements. Configure the scanner by entering program mode and scanning the appropriate bar codes that appear in the ScanSelect Scanner Programming Guide. (When using ScanSet™, refer to the ScanSet documentation for information on how to configure the scanner.)

1.Connect the scanner to the host system (Refer to the Scanner Connections to the Host section in this guide).

2.Enter program mode by scanning the ENTER/EXIT program mode bar code as the first bar code after a power up cycle. (The unit will beep three times)

3.Scan the appropriate bar code(s) that appear in the ScanSelect Scanner Programming Guide. (Reveal only one bar code to the scanner each time. With your hand, cover the bar code that is not to be scanned.)

4.Exit program mode by scanning the ENTER/EXIT program mode bar code again. (The new options will be saved and the scanner is ready for normal operation.)

Note: Non-RS-232 interfaces chosen in Section B of the ScanSelect Programming Guide do not match the default settings loaded when the same interface is selected with ScanSet.

4

Page 6 Page 8
Image 7
Page 6 Page 8
Contents MS700i Series Laser Bar Code Projection Scanner Installation and User’s GuideTable of Contents Appendix D Appendix aAppendix B Appendix CIntroduction Unpacking List Scanner Connections to the Host Configuration of the Scanner to the Host System Cloning Cloning FeatureVersion 11 IBM 46XX Scanner Configuring the Scanner IBM 4684 and 4694 Systems Configuring the IBMPC Type Scanner Installation to a PC Keyboard PortPage PC Application Note Installation of the MS700 Series Stand Attaching the Scanner to the Stand Scanner performs a good read of a bar code MS700i and MS720i Series FeaturesNo Red or Green LED Visual IndicatorsNi la diode rouge, ni la diode verte nest allumée Signaux optiquesWeder rote noch grüne Leuchtdiodenanzeige Optische AnzeigenNé il diodo luminoso rosso né quello verde sono accesi Segnali otticiVolume Settings Labels InfraRed IR Object Sensor Symbol Orientation Active Scan Region for the MS700i and MS715i Scanner Active Scan Region for the MS720i Scanner Page Horizontal Scan Width vs. Distance for the MS720i Scanner Depth of Field for the MS700i and MS715i Scanner Code Density Code TypeMil /1000 Page Depth of Field for the MS720i Scanner Element Mil /1000 Code Type Minimum Small Code DensityPage Applications and Protocols MaintenanceScanner Version Identifier Communication Protocols Electrical SpecificationsAppendix a MechanicalEnvironmental OperationalAppendix B Default SettingsSweda Three Beeps on Timeout No Beeps on IR Timeout Baud Rate Parallel Light 46XX Parallel Light Pen 46XX 232 Pin Function Appendix CEOT Version 2 Pin Assignments for Parallel CommunicationVersion 26 Pin Assignments for Multi-drop RS-422 Versions 11 and 24 Pin Assignments for RS-485 Pin Function Appendix D Warranty and Disclaimer Limited WarrantyDisclaimer Remarque Appendix EAnmerkung Patents Appendix FLED IndexLaserklasse UL/CSA/TUV
Top Page Image Contents