Yamaha PDM-4210E user manual Troubleshooting Symptoms That Appear to be Failures

Page 26

TROUBLESHOOTING (continued)

Symptoms That Appear to be Failures (continued)

Symptom	Point to check	See page

• The temperature of the display panel surface is high.	• Plasma display panel is lighting the phosphors in the display panel
	by the discharge of internal radiation. In some cases, this may	-
	cause the temperature of the panel surface to increase. Please	-

	note that this is not a malfunction.

•There are points (*) on the screen that differ in colour from • High-precision technology is used to manufacture the plasma

the periphery of the screen.	display panel, However in some cases, there are minor defects in
*Points that do not light, points with brightness different	some parts of the screen. Please note that this is not a	-
from that of the periphery, points with color different from	malfunction.
that of the periphery, etc.

•Vertical stripes appear, depending on the screen contents. • The plasma display panel is lighting the phosphors by the discharge of internal radiation. Depending on the screen contents,

	in rare cases this may cause vertical stripes to appear because of	-
	failure to light. Please note that this is not a malfunction.

• Coarse horizontal stripes appear in FULL display.	• Adjusting the Clock Phase will reduce the horizontal stripes.	20
	(RGB input)	20

•Flickering in the form of horizontal lines oscillating up and • If the direct frequency from the computer is below 85Hz, try a

down.	higher frequency (upper limit 85Hz). There may be a slight	20
(PC INPUT MODE only)	attenuation of the current image.	20

•Try turning the Vertical Filter On. For this case however, the vertical resolution will drop.

• The fan motor is noisy. (Fan application model only)	• Use the fan that controls the temperature in the main body to lower
	the temperature of this unit. If the ambient air temperature	-
	increases, the fan will start, the RPMs will increase and motor	-

	noise will grow louder. This is not a malfunction though.

• The top of the monitor heats up.	• When used for long periods of time, the top of the monitor may	-
	heat up. This is not a malfunction.	-

•Text characters are displayed with varying thicknesses. • The thicknesses of characters and lines may vary if images with a

vertical resolution greater than 512 lines are displayed; however,	-
this is not a malfunction.

ENGLISH

25

Image 26

Contents PDM-4210E English Features ContentsBe cautious of the power cord connection Never use the monitor if a problem occursUse only the correct power outlet Be sure to keep safety ground connectionBe careful in moving the monitor Be careful in handling the battery of the remote controlAvoid a high temperature environment Do not put anything on top of the monitorHow to view the monitor Remove the power cord for complete separationInstallation environment How to clean the plasma display panel of the monitorSet the sound volume at a suitable level Precaution during transportationDo not physically impact the remote control Precautions for the installationPrecautions Control panel Front Component NamesMain Unit RearLoading Batteries Component Names Remote controlHandling the Remote Control Anti-tumble measures Installation InstructionsInstallation Securing to a wall or pillarChoose a safe level location to install the product Installation InstructionsConnecting to a PC Monitor rear panelInstallation Instructions Power Cord Connection Turning Power On and Off Operating InstructionsWhen a button is pressed, the volume adjustment Operating Instructions Volume AdjustmentInput Switching Audio MuteDisplay area selection diagram RGB input Size SwitchingInput Signal Screen Display Operating InstructionsIndependent Operation of Multiple Monitors ID No Using the Menu Screen On-screen display systemAutomatic Adjustment of Screen Position and the Clock Picture Menu Audio Menu Timer MenuOff Timer Selected charactersFunction Menu Setup Menu MovieAutomatic Store Other FeaturesLanguage Menu Menu Display Registration conditionWhen the RGB, RGB2 input is selected Other Features Signal CheckPower Save Mode Status Display ActionAbout screen defects Image Retention of Plasma Display PanelMethods to Reduce the Occurrence of Image Retention About residual imagesSymptom Point to check See TroubleshootingSymptoms That Appear to be Failures Check to see if the input signal matches the monitorTroubleshooting Symptoms That Appear to be Failures SymptomTroubleshooting Actions to Correct Abnormal Displays ExampleRGB terminal D-sub 15-pin connector Product SpecificationsSignal Input Pin Input signalWith Digital RGB signal input RGB1 input Product Specifications Signal InputRecommended Signal List Pin Input signalProduct Specifications Recommended Signal List With Analog RGB signal input RGB2 inputSupplement DVI-STB and RGB component setup Connecting to a Video Imaging DeviceAn example of connecting video imaging devices Optional Video Unit FunctionDisplay size selection diagram Using a wide-screen monitor Position +Time will display 2 pictures Operating Instructions Displaying Multi PicturePictures Split YNR Black Enhancement Auto Colour Film Mode PAL Comb FilterOperating Instructions Picture Menu Red Colour ManagementMagenta YellowAV2 1st step AV2 2nd step System Colour SystemVideo Input Scart Output Operating Instructions Setup MenuAudio Input RGB2 1st stepSymptoms That Seemingly Appear to be Failures Symptom Point to checkPin Signal Input connector pin specificationsScart connector pin specifications Not UsedKHz MHz With R, G, B Video input AV2 and AV4 inputWith component input AV1, AV2 and RGB2-component input 525Freeze button Remote control provided for the optional tuner unitOptional Tuner Unit Function RGB / Video buttons Time buttonSurround On or Off Press this button to change input modePress these buttons to select a TV program directly Press this button to changeButtons for Teletext Mode Monitor rear panel Connecting AntennaPrecautions when connecting the antenna Auto Full Zoom 149Zoom C149L During TV modeTV AV1 AV2 AV3 RGB2 RGB1 AV4 Select buttons Multi Picture button Multi Mode button ButtonPictures Split 4 pictures 12 pictures Pictures Sound modeOff-timer NameSplit Strobe Picture FreezingFreeze button During TV mode AbcdeOff On Letter BG I DK Auto PAL Secam NTSC3.58 NTSC4.43 During Video signal inputPage1 Page2 Page3 TV MonitorBilingual / Dual sound broadcast Other FunctionsA2 / Nicam / Sound Multiplex Stereo sound broadcastOther brands Operating Instructions Other FunctionsDVD Player Selection ExampleMultiple images sound O.K Symptom Possible reason RemedySnowy picture poor sound Intermittent interferenceRF input Input terminals Remarques concernant ce Manuel Remarques concernant les travaux d’installationRemarques à l’attention des revendeurs