Siemens V1.0 user manual

Page 11

d)Select the PCStation and then double-click “Configuration” to bring up SIMATIC NCM PC Config (or STEP7 HW Config).

e)Insert the Application and IE General into the configuration matching the configuration previously set with the Station Configuration Editor as shown below.

- 11 -

Image 11

Contents ProfinetCommander Version History Table of ContentsHardware and Software Requirements IntroductionIP Address Subnet Mask Configuring the PC Station and the Profinet IO NetworkSelect the IP Addresses Double-click on Ethernet connection Edit the Station Configuration Add Application Select IE General Select Ethernet Card Configure the Profinet IO Network Page Page Page Page Page Page Download the Configuration to the PC Station Page Download the Profinet IO Device Names Exporting the Hardware Configuration to a File Using ProfinetCommander Starting ProfinetCommander Configuration Display Setting IO Device Outputs Setting the Run Mode to OperateDisplaying Diagnostic Alarms Reading Diagnostics Read Diagnostics Stored in IO Devices