PROJECTOR POSITION FOR 70" - 100" SCREEN SIZE
Installation using Wall Arm Bracket and Extension Bracket
9 | Snap extension cap (U) into extension bracket (B) in orientation as shown in figure 9.1. | |
Slide wall plate cover (E) onto wall arm bracket (C). | C | |
| Slide extension bracket (B) into wall arm bracket (C) in desired position. | |
B
UB
|
| FIGURE 9.1 | FIGURE 9.2 | E |
10 | Requirements for Shim Spacer |
|
| |
1. | When the front |
| ||
| assembly (A) goes through the extension bracket (B) and wall arm bracket (C). |
|
| |
| 2. | When there is a gap between the bottom of the projector attachment bracket (H) and the extension bracket (B). | ||
NOTE: If Shim spacer plate (I) is not required skip to step 11
Position exposed M5 x 20 mm socket pin serrated washer head screws (R) through slot in extension bracket (B) and wall arm bracket (C).Position screws in keyholes in projector attachment bracket (H), and hole in shim spacer plate (I) as shown in detail 3. Slide projector attachment bracket (H) toward wall. Once in locked position tighten all three M5 x 20 mm socket pin serrated washer head screws (R) using security wrench (Q) as shown in detail 4.
Secure extension bracket (B) into wall arm bracket (C) and secure using four M5 x 10 mm socket pin screws (T) in desired position. NOTE: Make sure that four M5 x 10 mm socket pin screws (T) are used.
SKIP TO STEP 12.
H
I 
T
KEYHOLE
SECOND HOLE
MAY ALSO BE
USED IF DESIRED
NOTE: Verify that all screws are in the center of the slot.
R
I
R
TIGHTEN |
SCREWS |
R |
A
FRONT OF PROJECTOR
FRONT OF PROJECTOR | FRONT OF PROJECTOR |
DETAIL 3 | DETAIL 4 |
10 of 14 |