Installation using Wall Arm Bracket and Extension Bracket
11 Attach exposed M5 x 20 mm socket pin serrated washer head screws (R) into top of adapter plate assembly (A) through slot in extension bracket (B) and keyholes in projector attachment bracket (H) as shown in detail 5.
Slide projector attachment bracket (H) toward wall. Once in locked position tighten all three M5 x 20 mm socket pin serrated washer head screws (R) using security wrench (Q) as shown in detail 6.
Secure extension bracket (B) into wall arm bracket (C) and secure using four M5 x 10 mm socket pin screws (T) using security wrench (Q) in desired position. NOTE: Make sure that four M5 x 10 mm socket pin screws (T) are used.
H 
B
T
A
FRONT OF PROJECTOR
NOTE: Verify that all screws are in the center of the slot.
R
FRONT OF PROJECTOR
DETAIL 5
TIGHTEN |
SCREWS |
R |
FRONT OF PROJECTOR
DETAIL 6
12 Route projector cables as shown. Use two cable management brackets (G) as needed.
Fasten two M5 x 20 mm socket pin serrated washer head screws (R) into top of adapter plate assembly (A).
B G
PROJECTOR CABLES
C
R
FRONT OF PROJECTOR
11 of 14 |