Peerless Industries UST-WallArm3 manual Remove knobs and M10 washers from top

Page 7

2	Remove knobs and M10 washers from top of
	adapter plate assembly (A).

KNOBS

M10 WASHERS

UPPER

ADAPTER PLATE

A

LOWER ADAPTER

PLATE

3	Place projector tilt plate (F) onto projector and
	secure using four M4 x 8 mm socket pin serrated

	washer head screws (L).	L
		L
		SHORT FLANGE
	F	OPPOSITE THE
	F	PROJECTOR
		PROJECTOR
		LENS

FRONT OF

PROJECTOR

MOUNTING LOCATIONS

FRONT OF

PROJECTOR

4	Secure lower adapter plate onto projector tilt plate (F) using four M6 x 10 mm socket pin screws (M).
	Re-fasten knobs and M10 washers from top of adapter plate assembly (A).

A	M

F

		KNOBS
	M10	UPPER	UPPER ADAPTER
	WASHERS	ADAPTER	UPPER ADAPTER
	WASHERS	ADAPTER	PLATE HOLES
		PLATE	PLATE HOLES
		PLATE

LOWER

ADAPTER

PLATE

NOTE: MAKE SURE THAT

UPPER ADAPTER PLATE

HOLES ARE CENTERED

WITH PROJECTOR LENS

7 of 14

ISSUED:07-25-11 SHEET #: 125-9225-1

Image 7

Contents Dukane Projector Short Throw Wall ARM Table of Contents Tools Needed for AssemblyCDE Screen Active Image Wall Plate LocationInstallation to Single Wood Stud Wall Installation to Solid Concrete or Cinder Block Remove knobs and M10 washers from top AR H Projector Position for 60 70 Screen Size Installation using Wall Arm BracketProjector Position for 70 100 Screen Size Installation using Wall Arm Bracket and Extension BracketProjector Cables Front of Projector Pitch Adjustment Roll AdjustmentCombination for Pitch and Roll Rotation Swivel AdjustmentSecure wall plate cover E to wall arm bracket C using two