3Carefully lower the serial controller through the opening in the front panel. The cables should remain connected to the serial controller.
You’ll notice that the I2C control panel flash cable is bundled with the DB9 serial cable.
4Using cutting pliers or wire cutters, cut the tie wraps as required to free the control panel flash cable.
5Connect this cable to the vertical jack on the serial controller.
Vertical Jack
I2C Control Panel
Flash Cable
6Reach inside the cabinet and attach the serial controller metal housing to the inside of the front panel. To do this, fit the two partially inserted screws on the metal housing into the keyholes on the front panel.
NOTE:
Avoid pinching any of the cables between the metal housing and the cabinet.
Connecting to a Third-Party Room-Control System
1Plug the 3000i power cable into a power outlet, turn on the computer, and take the projector out of Standby mode.
10 | Room Control Module Installation Guide for the 3000i |