Smart Technologies 3000i manual Vertical Jack I2C Control Panel Flash Cable

Page 12

2Reach inside the cabinet, behind the front panel. Lift the serial-controller metal housing up and then back to release it from the keyholes on the panel.

3Carefully lower the serial controller through the opening in the front panel. The cables should remain connected to the serial controller.

4Disconnect the I2C control panel flash cable from the vertical jack on the serial controller.

Vertical Jack

I2C Control Panel

Flash Cable

5Connect this cable to the female end of the I2C flash adapter cable. Then connect the male end of the I2C flash adapter cable to the vertical jack on the serial controller.

Vertical Jack

I2C Flash Adapter Cable

I2C Control Panel

Flash Cable

8

Room Control Module Installation Guide for the 3000i

99-00360-02 REV A0

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Room Control Module FCC Warning Contents Page Installing the Room Control Module About the Custom Straight-Through MOD4 I2C CablesRemoving the Blank Panel Completing the Computer 2 X-Port 20 Serial Panel Connections MOD4 I2C Cable Inserting the Room Control Module Reconnect the computer 2 serial cable Connecting the I2C Flash Adapter Cable Serial No Updating the Control Panel FirmwareVertical Jack I2C Control Panel Flash Cable Connecting the I2C Control Panel Flash Cable Serial No Connecting to a Third-Party Room-Control System Updating the Control Panel Firmware Use the following pin assignment for the cableTo update the control panel firmware Attempting to Program the Firmware on the Wonderbar Product Warranty Customer SupportContacting Smart Technical Support Other Smart Contacts
Top Page Image Contents