Removing the Blank Panel

NOTE: We recommend that you wear the supplied anti-static wrist strap throughout the installation process. This wrist strap protects electronic components from damage due to electrostatic discharge. Attach the adhesive side of the strap to your wrist and wrap the copper tape on the other end of the strip around either of the two screws shown below.

Cables removed from illustration for clarity

Wrap the copper tape on the anti-static wrist strap around either screw

1Shut down the computer, and put the projector into Standby mode. Wait a full minute to allow the fans to cool the projector, and then unplug the 3000i from the power outlet.

2With a Phillips No. 2 screwdriver, remove the four screws used to attach the blank panel at the left end of the patch panel (rear of cabinet). Discard the blank panel, but keep the screws handy. You’ll need them later to install the Room Control Module.

Cables removed from illustration for clarity

Screw x 4

Blank Panel

Patch Panel

Room Control Module Installation Guide for the 3000i

99-00360-02 REV A0