Paper Support
Power Switch
2.Turn On Typewriter
Raise the Paper Support and tum on the Power Switch located on the right side of the typewriter. The following initial operations occur."
1.A beep sounds and the
2.The Carder moves to the extreme left side and then moves to the left margin: The Printwheel rotates and stops at the programmed position.
While the above operations are occurring, all other type- writer functions stop. Start the next operation only after the initial operations are completed,
•Make sure the Printwheel, Ribbon Cassette and Correc- tion Tape are properly installed and that there is a suffi- cient quantity of ribbon and correction tape remaining,
3.Insert Paper
1)Insert paper between the Paper Support and Platen Roll- er.
Platen Knob.
Paper Bail
Knob
2)Turn the, Platen Knob on the left of the typewriter to advance the paper. When the top of the paper comes into sight, pull the Paper Bail upward by hand. to open it and continue turning the Platen Knob to feed paper in be- tween the Paper Bail and Platen Roller.
3)The paper is released when the Paper Release Knob is turned backward, enabling you to freely move the paper by hand for alignment purposes.
®Close the Paper Bail and return the Paper Release Knob to, its forward position before typing.