Sharp FO-475TH Error code table, Communication error code table G3 Transmission, G3 Reception

UX-258TH

FO-475TH

[4] Error code table

1.Communication error code table G3 Transmission

Code	Final received signal	Error Condition (Receiver side)
0	Incomplete signal frame	Cannot recognize bit stream after flag
1	NSF, DIS	Cannot recognize DCS signal by echo etc.
		Cannot recognize NSS signal (FIF code etc)
2	CFR	Disconnects line during reception (carrier missing etc)
3	FTT	Disconnects line by fall back
4	MCF	Disconnects line during reception of multi page
		Cannot recognize NSS, DCS signal in the case of mode change
5	PIP or PIN	The line is hung up without replying to telephone request from the receiving party.
6	RTN or RTP	Cannot recognize NSS, DCS signal after transmit RTN or RTP signal.
7	No signal or DCN	No response in receiver side or DCN signal received* (transmitter side)
8	−	Owing to error in some page the error could not be corrected although the specified number of
		error retransmission was at tempted.
11	−	Error occurred after or while reception by the remote (receiving) machine was revealed to be
		impossible.
12	−	Error occurred just after fallback.
13	−	Error occurred after a response to retransmission end command was received.

G3 Reception

Code	Final received signal	Error Condition (Receiver side)
0	Incomplete signal frame	Cannot recognize bit stream after flag
1	NSS, DCS	Cannot recognize CFR or FTT signal
		Disconnects line during transmission (line error)
2	NSC, DTC	Cannot recognize NSS signal (FIF code etc)
3	EOP	Cannot recognize MCF, PIP, PIN, RTN, RTP signal
4	EOM	Cannot recognize MCF, PIP, PIN, RTN, RTP signal in the case of mode change
5	MPS	The line is hung up without replying to communication request.
6	PR1-Q	Cannot recognize PIP, PIN signal in the case of TALK request
7	No signal or DCN	No response in transmitter (cannot recognize DIS signal) or DCN signal received* (receiver side)
8	−	Error occurred upon completion of reception of all pages.
9	−	Error occurred when mode was changed or Transmission/Reception switching was performed.
10	−	Error occurred during partial page or physical page reception.
11	−	Error occurred after or during inquiry from the remote (transmitting) machine as to whether
		reception is possible or not.
12	−	Error occurred during or just after fallback.
13	−	Error occurred after the retransmission end command was received.

2 – 18