Sharp FO-475TH, UX-258TH manual Specifications

CHAPTER 1. GENERAL DESCRIPTION

[1] Specifications

Automatic dialing:	Rapid Key Dialing: 10 numbers
	Speed Dialing: 20 numbers
Fax paper:	Initial starter roll (included with fax
	machine): 10 m roll
	Recommended replacement roll:
	FO-40PR 50 m roll
Automatic document feeder:	10 sheets max.
Paper cutting method:	Automatic cutter
Modem speed:	9600 bps with automatic fallback to
	7200, 4800, or 2400 bps
Transmission time* :	Approx. 15 seconds (Sharp special mode)
Display:	7 x 5 dots, 1 line by 16-digit display
Reception modes:	TEL, FAX, TEL/FAX, ANS.
Resolution:	Horizontal:
	8 dots/mm
	Vertical:
	Standard: 3.85 lines/mm
	Fine/Halftone: 7.7 lines/mm
	Super fine: 15.4 lines/mm
Recording system:	Thermal recording
Halftone (grayscale):	64 levels
Applicable telephone line:	Public switched telephone network/PBX
Compatibility:	ITU-T (CCITT) G3 mode
Configuration:	Half-duplex, desktop transceiver
Compression scheme:	MH, MR, Sharp special mode
Scanning method:	Sheet-feeder CIS (Contact Image Sensor)
Effective recording width:	210 mm max.
Input document size:	Automatic feeding:
	Width ⎯ 148 to 216 mm
	Length ⎯ 140 to 297 mm
	Manual feeding:
	Width ⎯ 148 to 216 mm
	Length ⎯ 140 to 600 mm

UX-258TH

FO-475TH

Effective scanning width:	210 mm max.
Contrast control:	Automatic/Dark selectable
Copy function:	Standard
Telephone function:	Standard
	(cannot be used for incoming/outgoing
	if power fails)
Power requirements:	220-240 V, 50 Hz
Operating temperature:	5 to 35°C
Humidity:	Maximum: 85 %
Power consumption:	Stand-by: 6.0 W
	Maximum: 120 W
Dimensions:	Width: 308 mm
	Depth: 256 mm
	Height: 138 mm
Weight:	Approx. 2.6 kg
	(without attachements)

*Based on ITU-T (CCITT) Test Chart #1 at standard resolution in Sharp special mode, excluding time for protocol signals (i.e., ITU-T phase C time only).

As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for procduct improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some deviation from these values in individual units.

1 – 1