Multi-Tech Systems MVP 800 manual MultiVOIP Application, Sales Office

Page 8

Chapter 1 - Introduction and Description

MultiVOIP Application

A typical Voice Over IP (VOIP) network is shown in Figure 1-2 with a headquarters site and three remote sites (Sales office, regional and marketing offices). This typical Voice Over IP network can be set up via the Internet or your Intranet. The headquarters site is set up with a 8-channel MultiVOIP (MVP 800) connected to the headquarters LAN and eight voice/fax channels connected to the in- house telephone switch (PBX), only 4-channels are shown in Figure 1-2. Typically, the MultiVOIP at the headquarters site would be set up as the host unit. The host unit controls the phone directory data base which is sent to each site on a periodic basis or if a new telephone number is added.

PSTN

Headquarters

 

 

E&M Interface

512-4124

 

7

104

 

P

6

103

512-4123

B

5

102

4

101

 

X

 

 

 

512-4122

201.23.122.118

Internet/

Intranet

Sales Office

PSTN

202

FXO

 

522-5125

201

 

(5127)

522-5124

FXS

KTS

522-5123

205.24.123.119

 

206.25.124.120

207.26.125.121

 

PSTN

 

 

 

 

#301

 

 

 

 

 

 

 

 

401

 

 

#302

FXS Interface

402

9

P

532-6128

 

 

 

10

B

 

 

Regional Office

E&M Interface

X

532-6129

 

 

 

Marketing Office

Figure 1-2. Example of a MultiVOIP application

The sales office is set up with a two voice/fax channel MultiVOIP series connected to the IP network and one voice/fax channel connected directly to the local Public Switch Telephone Network (PSTN). The second voice/fax channel is connected to the trunk side of a Key Telephone System (KTS). This allows an attendent to direct an incoming call to one of the two telephone extensions or to the fax machine.

The regional office is set up with two analog telephones connected directly to a two voice/fax channel MultiVOIP. This allows a person in the corporate office to dial out thru the MultiVOIP 800 at the corporate office and call directly into the person at extension 301.

The MultiVOIP at the marketing office is set up on the trunk side of the PBX (E&M interface) so that you could dial into the marketing office, seize a trunk, then dial an outside line to make a local call or connect directly to a telephone extension on the PBX or in this case to the fax machine at extension 6129.

A phone directory database is maintained on one of the MultiVOIPs which is configured as a “host”. This phone directory is retrieved by the remaining “client” MultiVOIPs on your Voice Over IP network.

Each phone number entry corresponds to a MultiVOIP IP address and associated voice/fax channel number. With this system, you need only update the “host” phone directory when deploying additional MultiVOIPs to your Voice Over IP network.

8

Image 8
Contents User Guide User Guide Record of Revisions RevisionDescriptionContents Glossary Index Introduction and Description Introduction Preview of this GuideAppendixes Remote Configuration and ManagementWarranty, Service and Tech Support MultiVOIP Application Sales OfficePhone Directory Data Base Voip Dialing Directory Front Panel Description EthernetPower Connector Command Port Connector10Base-T Ethernet Connector Back Panel DescriptionSpecifications Command PortEthernet Port Electrical/PhysicalInstallation Installing Your MultiVOIP Safety Warning TelecomConfigure and Install your Host MultiVOIP Configure your Client MultiVOIPsValid Voip Network Connections Safety WarningsUnpacking Your MultiVOIP Cabling Procedure Cable ConnectionsJumper Block Positioning Procedure E&M Jumper BlockSoftware Loading and Configuration Configuring Your Host MultiVOIP Software Loading and Configuration IP Protocol Default Setup dialog box displays Software Loading and Configuration Software Loading and Configuration Software Loading and Configuration Software Loading and Configuration Software Loading and Configuration Software Loading and Configuration Configuring Your Client MultiVOIPs Page Software Loading and Configuration Software Loading and Configuration Software Loading and Configuration Software Loading and Configuration Voip Administrator Deploy the Voip NetworkSoftware Loading and Configuration MultiVOIP Software Before You Begin MultiVOIP Configuration FXS Interface Changing Channel ParametersInterface Tab FXO Disconnect On FXO InterfaceInterface Voice/Fax Tab MultiVOIP Software Regional Tab Changing the Phone Directory Database MultiVOIP Software Proxy Setup Changing IP ParametersMultiVOIP Software Viewing Statistics IP StatisticsSnmp Statistics Others Setup Viewing Call Progress Viewing Channel Totals Viewing LogsViewing Log Entry Details Reports Remote Configuration and Management Remote Configuration Modem-BasedRemote Configuration and Management LAN-Based Remote Configuration and Management MultiVOIP Telnet Server Menu Remote ManagementTelnet Voice over IP Configuration Phone Directory ConfigurationWEB Management Phone Directory DatabaseRemote Configuration and Management Upgrade Procedures One-Step UpgradeManual Upgrade Procedure Warranty, Service, and Tech Support Warranty, Service, and Tech Support Limited Warranty On-line Warranty RegistrationContacting Technical Support Tech SupportRecording MultiVOIP Information Service About the InternetAppendixes Appendix a TCP/IP Description Appendix a TCP/IP Description Internet Protocol IP Appendix B Cabling Diagrams Command Port CableVoice/Fax Channel Connectors LAN CableMVP 400/800 Magix 400 E&M Connection Wire Tire Card Magix 400 E&M Tie CardAppendix C Regulatory Information Class a StatementFax Branding Statement FCC PartFCC Part 68 Telecom RENRinger Equivalence Number EMC, Safety and Terminal Directive ComplianceCanadian Limitations Notice Glossary Glossary Glossary Glossary Glossary Glossary Glossary Glossary Glossary Glossary Subscriber Loop See Local loop Glossary Glossary Index