BT PaperJet 40 UG – Issue 2 – Edition 2 – 18.03.04 – 6026
36Installing a new ink film
Only your starter ink film does not require a Plug ‘n. Print card.
IMPORTANT
Use only BT ink films compatible with your machine.
Ink film rolls are available from most fax/printer retailers.
Or you can order ink films direct from 0870 240 7285.
Lines open 9.30 am – 5.30 pm,
Your BT PaperJet 40 is supplied with a starter ink film, enough to print a few papers.
You will then need to insert a new ink film. Each new film comes with a Plug ‘n’ Print card which holds its consumption and setting details and which must be inserted into the machine.
Only the starter ink film works without a Plug ‘n’ Print card as the settings were made at the factory.
Ink level indicator
The display shows you how much is available .
If the ink film is finished or if no ink film is installed, the display shows and the red warning indicator will flash.
You will also receive a printed warning when the ink film is running low.
Plug ‘n’ Print card indicator
If the Plug ‘n’ Print card is not inserted or replaced when a new ink film is installed, the display shows CHANGE CARD.
When installing a new ink film you must insert the Plug ‘n’ Print card that comes with it.
Install a new ink film
1.Remove the handset and any paper from the paper tray.
2.Lift the control panel until it clicks open.