ATM-25 SERVICE
If your service provider is providing
System Requirements
The Alcatel 1000 ADSL high speed modem requires a PC or workstation equipped with an ATMF 25.6 Mb/s network adapter card that supports encapsulations and protocols described in RFC 1483 and RFC 2364.
Hardware Installation
To connect your high speed ADSL modem, follow these steps:
1.Make sure the modem on/off switch is set to the O (off) position.
2.Connect the jack end of the power cable to the modem power socket.
3.Plug the other end of the power cable (the end with the power supply adapter) to an electrical outlet.
4.Connect one end of a standard telephone cable (not provided) to the modem connector labeled LINE.
Note:
The line cable may be provided by your service provider during installation, or it can be purchased at your local electronics supply store.
5.Connect the other end of the line cable to a phone jack.
6.Connect one end of the Alcatel data cable (provided) to the modem connector labeled
7.Connect the other end of the Alcatel data cable to the ATMF 25.6 Mb/s network adapter card in your PC.
8.Start your PC.
9.Turn on the modem by switching the on/off switch to .