One Tunnel
Windows 95 and Windows 98 allow you to create only one tunnel at a time. This means that you cannot connect to an ISP and the corporate network simultaneously.
Tunneling within a Tunnel
Tunneling within a tunnel is not possible with Windows 95 because of its single tunnel limitation.
Note:
Windows NT does not share these two limitations. It is possible to create multiple tunnels and simultaneously connect to multiple remote destinations. A tunnel within a tunnel is also possible, assuring better
Local Connection is Lost
After you create a tunnel, communication with local workstations may be lost. This is because the Windows operating system adds a new default gateway to its routing table. This new default gateway points to the tunnel. Because TCP/IP is designed to use only one default gateway, connection through the original gateway is lost.
When the tunnel is terminated, connection through the original default gateway is reestablished.
You can avoid this problem by manually adding routes to local destinations in the routing table.
ADVANCED CONFIGURATIONS
Overview
Access to an ISP or corporate network typically requires minimal configuration for
This connection is made through the Ethernet port of the modem. An IP address is configured to allow a web browser in the PC to communicate to the modem.
The following are options for local connection to the modem: