HP BMD00022 manual Link Aggregation Control Protocol configuration, Lacp Port configuration, Prio

Link Aggregation Control Protocol configuration

Command: /cfg/l2/lacp

[LACP Menu]
sysprio	- Set LACP system priority
timeout	- Set LACP system timeout scale for timing out partner info
port	-	LACP port Menu
cur	-	Display current LACP configuration

The following table describes the LACP Configuration Menu options.

Table 120 LACP Configuration Menu options

Command	Description
sysprio <1-65535>	Defines the priority value (1 through 65535) for the switch. Lower numbers
	provide higher priority. The default value is 32768.
timeout shortlong	Defines the timeout period before invalidating LACP data from a remote
	partner. Choose short (3 seconds) or long (90 seconds). The default
	value is long.
	HP recommends that you use a timeout value of long, to reduce LACPDU
	processing. If your switch’s CPU utilization rate remains at 100% for periods
	of 90 seconds or more, consider using static trunks instead of LACP.
port <port number>	Displays the LACP Port menu.
cur	Display current LACP configuration.

LACP Port configuration

Command: /cfg/l2/lacp/port <port number>

[LACP Port 2 Menu]

mode	- Set LACP mode
prio	- Set LACP port priority
adminkey	-	Set LACP port admin key
cur	-	Display current LACP port configuration

The following table describes the LACP Port Configuration Menu options.

Table 121 LACP Port Configuration Menu options

Command	Description
mode offactivepassive	Set the LACP mode for this port, as follows:
	• off—Turn LACP off for this port. You can use this port to manually
	configure a static trunk. The default value is off.
	• active—Turn LACP on and set this port to active. Active ports initiate
	LACPDUs.
	• passive—Turn LACP on and set this port to passive. Passive ports do
	not initiate LACPDUs, but respond to LACPDUs from active ports.
prio <1-65535>	Sets the priority value for the selected port. Lower numbers provide higher
	priority. The default is 128.

Configuration Menu 151