HP BMD00022 manual Layer 3 information, Command /info/l3

Layer 3 information

Command: /info/l3

[Layer 3 Menu]
route	- IP Routing Information Menu
arp	- ARP Information Menu
ospf	- OSPF Routing Information Menu
rip	- RIP Routing Information Menu
ip	- Show IP information
igmp	- Show IGMP Snooping Multicast Group information
vrrp	- Show Virtual Router Redundancy Protocol information
sm	- Server Mobility Information Menu
dump	- Dump all layer 3 information

The following table describes the Layer 3 Information Menu options.

Table 26 Layer 3 Information Menu options

Command	Usage
route	Displays the IP Routing Menu. Using the options of this menu, the system displays the
	following for each configured or learned route:
	• Route destination IP address, subnet mask, and gateway address
	•	Type of route
	• Tag indicating origin of route
	• Metric for RIP tagged routes, specifying the number of hops to the destination (1-15
		hops, or 16 for infinite hops)
	• The IP interface that the route uses
arp	Displays the Address Resolution Protocol (ARP) Information Menu.
ospf	Displays OSPF routing Information Menu.
rip	Displays Routing Information Protocol Menu.
ip	Displays IP Information. IP information, includes:
	• IP interface information: Interface number, IP address, subnet mask, VLAN number,
		and operational status.
	• Default gateway information: Metric for selecting which configured gateway to use,
		gateway number, IP address, and health status
	• IP forwarding information: Enable status, lnet and lmask
	•	Port status
igmp	Displays IGMP Information Menu.
vrrp	Displays the VRRP Information Menu.
sm	Displays the Server Mobility Information Menu.
dump	Dumps all switch information available from the Layer 3 Menu (10K or more, depending
	on your configuration).

If you want to capture dump data to a file, set your communication software on your workstation to capture session data prior to issuing the dump commands.

Information Menu 50